5M Waterproof IP20 WS2813 LED strip with white PCB Colorful DC 5V led lights Like horse running for water decoration

Features and Benefits

The control circuit and the LED share the only power source.

The control circuit and RGB chip are integrated in a 5050 components, to form an external control pixel.

Using the built-in signal reshaping circuit to achieve the signal waveform shaping, and no distortion of waveform of signal takes place.

Built-in power-on reset and brown-out reset circuits.

The gray levels of each pixel are of 256 levels, which achieves “256*256*256=16777216” full-color display, and the refresh frequency reaches to 2KHz/s.

Serial cascade interface, data receiving and decoding depend on just one signal line.

Dual-signal wires version, signal break-point continuous transmission.

Any two point the distance more than 3m transmission signal without any increase circuit.

When the refresh rate is 30fps, cascade numbers are far more than 1024 points.

Data transmitting at speeds of up to 800Kbps.

Good color consistency reliability, high cost-effective.
Patameter:

 

Connection:
1) Signal wire: DC+, DAT,CLK, GND
2) DC+ and GND connect to power supplier; DAT,CLK and GND connect to controller
3) Relative Controller: SPI controller support ws2811; when use DMX decorder, can connect to DMX system
4) Support online control

 

Color:
1) Each pixel can be controlled individually
2) Can show any color
3) Can be used as flexible led display screen to show image and video

 

Installation Notice:
1) Make sure the connection is correct according to the diagram
2) Pay attention to the parameters limit of voltage. DO NOT run over the peak value
3) Keep the surface of installation clean and smooth avoid breaking off
4) Avoiding the crook area just the position of LED and other components, in order to protect the product and extend the life span of the product

Controller: DMX controller & decoder & SD controller & arduino controller

Change color individually and addressable full color