Seamless Butt Welding Reducer 24”*10” SCH-80 Alloy K-500 ASTM/UNS N05500

Seamless Butt Welding Reducer 24”*10” SCH-80 Alloy K-500 ASTM/UNS N05500

Introduction

Reducer, also known as reducer, is one of the chemical pipe fittings, which is used for the connection of two different pipe diameters. It is also divided into concentric reducer and eccentric reducer.

The big and small heads whose center is in a straight line are called concentric big and small heads. The commonly used forming process is reduced diameter pressing, expanded diameter pressing or reduced diameter plus expanded diameter pressing. Stamping can also be used for reducing pipes of some specifications.

Overview and features:Alloy K-500

This nickel alloy is spark resistant and non-magnetic - 200 ° F However, a magnetic layer surface can be developed during material processing. Aluminum and copper may be selectively oxidized during heating, leaving a magnetic nickel rich film. Pickling or bright pickling can remove this magnetic film and restore non-magnetic properties

N05500 corrosion resistance

The corrosion resistance of n05500 alloy is essentially equivalent to alloy 400. In addition to age hardening, n05500 nickel alloy has a greater tendency of stress corrosion cracking in some environments. N05500 was found to be an acid gas resistant environment. The combination of very low corrosion rate in high-speed coke baking water and n05500 high-strength alloy is especially suitable for the service of shaft marine centrifugal pump. In stagnant or slow seawater, pollution may occur, followed by pitting, but this allows a fairly rapid initial attack after slowing down.

N05500 manufacturing

The welding alloy n05500 is preferably welded by tungsten electrode inert gas welding process. It is recommended that Monel n05500 is annealed when welding before any weldment is pressure relieved.

The best completion conditions or hot working and quenching conditions for alloy materials processed by heavy machinery during annealing. However, age hardening materials can be finished to close tolerances for good completion. Therefore, it is recommended that the machine be slightly larger, age hardened, and then machined to size. During aging, slight permanent shrinkage occurs, but small bending is due to low temperature and slow cooling rate

Q1: Are you trading company or manufacturer ?

A: We are factory.

Q2: How long is the delivery ?

A: 15-30 working days

Q3: Do you provide samples ? is it free or extra ?

A: Yes, we could offer the sample for free charge but do not pay the cost of freight.

If you want to get more information of the products, send me e-mail or by skype, whatsapp etc.

.

If any questions,you can call me mobile phone at any times:0086-15710108231