The main reasons for the fuel injection nozzle jamming.
1 Diesel fuel is not clean, impurities in the high-pressure oil
pipe, so that the needle valve coupling is not closed tightly, the
combustion chamber in the high-pressure gas rebound, burned needle
valve coupling. In addition, the injector regulator spring, tappet
and other parts of the dirt through the injector tappet moved to
the upper part of the injector needle valve, or oil road used to
prevent oil leakage of cotton rope, lead wire through the
high-pressure oil pipe into the injector, will make the needle
valve coupling jammed.
2 The machine temperature is too high injector cooling is poor,
resulting in the oil valve coupling stuck.
3 The oil valve wear, so that when the injector stops spraying oil
drip phenomenon, so that the injector nozzle burning coke
accumulation, the occurrence of jammed failure.
4 Injector installation, omission of gaskets or gasket damage,
resulting in air leakage, causing the injector local temperature is
too high and stuck.
5 The injection pressure is too low, resulting in the combustion
chamber of high-pressure gas backflow.
6 Parts manufacturing reasons, such as cylinder head injector
mounting holes and injectors with too tight, needle valve body and
cylinder head mounting hole clearance is too small, cylinder head
injector mounting hole processing too deep. Product Description
Injection nozzle stuck repair method.
First, the stuck injector into the diesel or oil warming, and then
remove the cloth wrapped, and then clamp the needle valve with hand
pliers and slowly move, the needle valve from the needle valve body
out. A small amount of clean oil drops in the body of the needle
valve, so that the needle valve in the body of the needle valve
repeated activities, until the needle valve can move freely in the
body of the needle valve. If the sealing surface of the needle
valve has traces of burns, it should be ground with abrasive paste.
When grinding, pay attention to grasp the amount of grinding paste
and grinding time. The cleaned bell valve coupling will be
installed on the injector, and adjust the injection pressure can be
used again.
No. | Part Number | Description |
1 | 12VB.16.01 | Cap |
2 | 12V.16.02 | Washer |
3 | 12V.16.03 | Lock nut |
4 | 12VB.16.04 | Pressure adjusting screw |
5 | 12VB.16.05 | Upper spring seat |
6 | 12V.16.06A | Pressure adjusting spring |
7 | 12VB.16.10 | Tappet subassembly |
Daily maintenance parts include: spark plugs, magneto, ignition
coils, high voltage cables, etc., cylinder liners, ignition coils,
pistons, piston rings, air filter, oil filter, diesel filter,
intake valves, exhaust valves, valve seats, motors, cylinder heads,
exhaust pipes, various gaskets and screws, bellows, bodies,
crankshafts, camshafts, intercoolers, superchargers, connecting rod
tiles, shaft tiles, STITT spark plugs, MOTORTECH spark plugs,
pre-ignition chamber spark plugs, four-pack etc.
Export Case
Detailed Photos
Certifications
Our Advantages
1.Passed ISO9001 quality system certification and ISO14001
environmental system certification.
2.The company has entered into in-depth cooperation with equipment
research institutes and advanced equipment manufacturers.
3.Applications: enterprises with gas sources such as biogas,
industrial tail gas, gas, natural gas, gas, tyre cracking gas,
biomass gas, etc.
4.The business covers the sale, rental and maintenance of
generating sets, power station construction and cooperative power
generation