Active Member
|
[China]
Address: Room 617, Guanlida Building, NO. 269 of Qianjin Road, Wenhui community, Xin'an street
Contact name:Frank
Shenzhen zk electric technology limited company |
|
|
AC drive 220V 380V 30kw 22kw 40HP VSD VFD Variable Frequency Inverter
ZUN/ZK SU100-T3-030G/037P 30KW single phase frequency inverter
Products Introduction
Thanks to sophisticated engineers, scientific producing
workmanship, rigorous quality control systems and management team,
ZK SU100 series frequency inverters are equipped with advanced
features, some of which are listed as below:
01 Starting torque: 180%, 0.25Hz (sensor-less vector control 2),
150%, 0.5Hz (sensor-less vector control 1);
02 Speed adjustable range: 0-50Hz: 1:200 (sensor-less vector
control 2), 1:100 (V/Hz control, sensor-less vector control 1);
03 Speed accuracy: +/-0.2% (sensor-less vector control 1&2),
+/-0.5% (V/Hz control);
04 Speed fluctuation: +/-0.3% (sensor-less vector control 1&2);
05 Torque response: less than 10ms (sensor-less vector control
1&2);
06 Over load capability: 150% 1minute, 180% 10 seconds, 200% 0.5
second, once every 10 minutes;
07 Output frequency: 0.00-600.00Hz, or customized like 1MHz;
08 Abundant frequency setting sources;
09 DC brake start frequency: any frequency in the range of 0Hz to
600.00Hz;
10 Diverse input and output terminals;
11 Ambient temperature: -10°C~50°C;
12 High precise torque limit, process PID control, simple PLC,
wobble frequency control, mechanical brake control, field weakening
control, all-side protection, etc.
13 Online and offline auto-tuning both available;
14 Extreme short-time acceleration can be operated without trip,
such as 0.1s from 0Hz to 50Hz.
Technical Specifications
| Item | Specification | |
| Power input | Voltage,frequency | 1AC 220VAC(±20%) for 2S model 3AC 220VAC(±20%) for 2T model 3AC 380VAC(±20%) for 4T/T3 model |
| Allowable fluctuations | voltage unbalance rate:<3%; Frequency:±5%; aberration rate: as IEC61800-2 required | |
| Power factor | ≥0.94(with DC reactor) | |
| Efficiency | ≥96% | |
| Output | Output voltage | Output under rated condition: 3 phase, 0～input voltage, inaccuracy<5% |
| Output frequency range | G type:0～600Hz | |
| Output frequency accuracy | Max frequency ±0.5% | |
| Overload capacity | G type: 150% rated current/1 min, 180% rated current/10s, 200% rated current/0.5s | |
| Main control performance | Motor control mode | V/F without PG , VC without PG , VC with PG |
| Speed control range | Vector control without PG, rated load 1:100;Vector control with PG, rated load 1:1000; | |
| Steady speed accuracy | VC without PG: ≤2% rated synchronized speed; | |
| VC with PG: ≤0.05% rated synchronized speed | ||
| Starting torque | VC without PG: when 0.5Hz, 150% rated torque; | |
| VC with PG: when 0Hz, 200% rated torque | ||
| Torque response | VC without PG: ≤20ms; | |
| VC with PG: ≤10ms. | ||
| Frequency accuracy | Digit setting: max frequency×±0.01%; | |
| Analog setting: max frequency×±0.2% | ||
| Frequency resolution | Digital setting: 0.01Hz; | |
| Analog setting: maximum frequency × 0.05% | ||
| DC braking capacity | Starting frequency:0.00～50.00Hz; Braking time:0.0～60.0s; | |
| Braking current:0.0～150.0% rated current | ||
| Torque boost capacity | Auto torque upgrade 0.0%～100.0%; | |
| Manual torque upgrade 0.0%～30.0% | ||
| V/F curve | 4 modes: one linearity torque characteristic curve ,one self-setting V/F curve mode, one drop torque characteristic curve (1.1- 2.0 powers),and square V/F curve mode. | |
| Acceleration/Deceleration curve | 2 modes: linear Acceleration/Deceleration and S curve Acceleration/Deceleration. | |
| 4 sets of ACC/DEC, time unit 0.01s selectable, longest time: 650.00s. | ||
| Rated output voltage | Rely on power supply voltage compensate function, while motor rated voltage is 100%, set it at the range of 50-100%(output can not over input voltage). | |
| Voltageauto-adjustment | While power supply voltage fluctuates, it can auto-keep constant output voltage. | |
| Auto energy-saving running | While under V/F control mode, according to load situation, auto-optimize output voltage to save energy. | |
| Standard functions | PID control, speed track, power off restart, jump frequency, upper/lower frequency limit control, program operation, multi- speed, RS485, analog output, frequency impulse output. | |
| Product | Frequency setting channels | Keyboard digital setting, keyboard potentiometer ,Analog voltage/current terminal AI1,AI2, Communication given and multi-channel terminal selection,Main and auxiliary channel combination,expansion card, supporting different modes switch. |
| basic functions | Feedback input channel | Voltage/Current Terminal AI1, Voltage/Current Terminal AI12, Communication |
| given, pulse input X5. | ||
| Running command channel | Operation panel given,external terminal given, communication given, expansion card given. | |
| Input command signal | Start, stop, FWD/REV, JOG, multi-step speed, reset, ACC/DEC time selection, frequency given channel selection, exterior fault alarm. | |
| Protective function | Overvoltage, under-voltage, current limit, over-current, overload, electric thermal relay, overheat, overvoltage stall, data protection, rapid speed protection, input/output phase failure protection. | |
| Environment | Install place | altitude ≤ 1000m,above 1000m down the rated amount, each increase of 100m down the ratedmount of 1%;no condensation, ice ,rain, snow, hail; solar radiation below 700W/㎡, air pressure 70-106 kPa. |
| Temperature, humidity | -10 ～ + 50 ℃, derating above 40 ℃, maximum temperature 60 ℃ (no-load operation)5% to 95% RH (non-condensing) | |
| Vibration | When 9～200Hz, 5.9m/s2(0.6g) | |
| Storage temperature | -30 ～+60℃ | |
| Protection grade | IP20 | |
| Cooling method | Forced air cooling | |
Model List
| Model | Power Supply Capacity(KVA) | Input Current(A) | Output Current(A) | Output Voltage(VAC) | Applicant Motor | Dimensions(mm) W*H*D | |
| mini type: Single-phase power: 220v, 50/60Hz | KW | HP | |||||
| SU10-2S0.75GB | 0.75 | 5.4 | 2.3 | 0-220 | 0.4 | 0.5 | 86*162*128 |
| SU10-2S1.5GB | 1.5 | 8.2 | 4 | 0-220 | 0.75 | 1 | 91*175*128 |
| SU10-2S2.2GB | 2.2 | 14 | 7 | 0-220 | 1.5 | 2 | |
| mini type: Three-phase power: 380v, 50/60Hz | |||||||
| SU10-4T0.75GB | 0.75 | 3.4 | 3/4 | 0-380 | 0.75 | 1 | 86*162*128 |
| SU10-4T1.5GB | 1.5 | 5 | 4/6 | 0-380 | 1.5 | 2 | |
| SU10-4T2.2GB | 2.2 | 5.8 | 6/9.2 | 0-380 | 2.2 | 3 | |
| SU10-4T4.0GB | 4 | 11 | 9.2/13 | 0-380 | 3.7 | 5 | 91*175*128 |
| General type: Three-phase power: 380v, 50/60Hz | |||||||
| SU100-T3-R75G/1R5P-B | 0.75/1.5 | 3.4 | 3/4 | 0-380 | 0.75 | 1 | 89*190*135 |
| SU100-T3-1R5G/2R2P-B | 1.5/2.2 | 5 | 4/6 | 0-380 | 1.5 | 2 | |
| SU100-T3-2R2G/004P-B | 2.2/4 | 5.8 | 6/9.2 | 0-380 | 2.2 | 3 | |
| SU100-T3-004G/5R5P-B | 4/ 5.5 | 11 | 9.2/13 | 0-380 | 3.7 | 5 | 106*230*148 |
| SU100-T3-5R5G/7R5P-B | 5.5 / 7.5 | 14.6 | 13/17 | 0-380 | 5.5 | 7.5 | |
| SU100-T3-7R5G/011P-B | 7.5/ 11 | 20.5 | 17/25 | 0-380 | 7.5 | 10 | |
| SU100-T3-011G/015P-B | 11/15 | 26 | 25/32 | 0-380 | 11 | 15 | 130*275*160 |
| SU100-T3-015G/018P-B | 15 / 18 | 35 | 32/37 | 0-380 | 15 | 20 | |
| SU100-T3-018G/022P-B | 18 / 22 | 38.5 | 37/45 | 0-380 | 18.5 | 25 | 155*335*191 |
| SU100-T3-022G/030P-B | 22 / 30 | 46.5 | 45/60 | 0-380 | 22 | 30 | |
| SU100-T3-030G/037P | 30 / 37 | 62 | 60/75 | 0-380 | 30 | 40 | 195*445*420 |
| SU100-T3-037G/045G | 37 / 45 | 76 | 75/90 | 0-380 | 37 | 50 | |
| SU100-T3-045G/055P | 45 / 55 | 92 | 90/112 | 0-380 | 45 | 60 | 240*560*520 |
| SU100-T3-055G/075P | 55 / 75 | 113 | 112/150 | 0-380 | 55 | 75 | |
| SU100-T3-075G/093P | 75 / 93 | 157 | 150/176 | 0-380 | 75 | 100 | |
| SU100-T3-093G/110P | 93 / 110 | 180 | 176/210 | 0-380 | 90 | 120 | 270*640*582 |
| SU100-T3-110G/132P | 110 / 132 | 214 | 210/253 | 0-380 | 110 | 150 | |
| SU100-T3-132G/160P | 132 / 160 | 256.0 | 253/304 | 0-380 | 132 | 175 | |
---FAQ---
Q1: Are you a manufacturer or trading company?
A: We are a inverter/VFD manufacturer.
Q2: Can you accept to use our logo?
A: we accept OEM production.
Q3:How can i get the after-service?
A: Our R&D team with more than 20 years experience in this field. If there's any problem, please feel free to contact us, we'll provide suggestion from our engineer to help you solve the problem.
Q4: What is your terms of payment ?
A:We accept T/T, L/C,paypal, western union,etc.The details you can discuss with us.
Q5:Do you provide warranty for the goods?
A: Yes, we provide 18 months of warranty for all the goods from us.
Q6: How about your products quality inspection?
A: We have professional QA and QC teams, 100% quality inspection is performed before goods out of factory.
Welcome to contact SHENZHEN ZK, we provide the best!
