Memorial Arch Gearbox Drive Metal Cruss Barrier Roll Forming Machine Line Speed 10m / Min

Memorial Arch Gearbox Drive Metal Cruss Barrier Roll Forming Machine Line Speed 10m/min

Main feature

The metal cruss barrier guardrail roll forming machine can be designed as two or three wave profiles in one machine, you just need to add some stations at the end of the machine. The guardrail roll forming machine composed with 5 ton manual decoile, feeding guide device, straighten and leveling device, front hydraulic punching device, roll forming machine, hydraulic cutting and auto stacker or manual stacker for finished products.

Working flow

Technical parameters

1) Decoiler

Hydraulic decoiler
Single unrolling machine, one side can put material
Adopt automatic hydraulic system
Coil weight (Max): 5000kg
Coil dia (Max): 1600mm
Oil cylinder dia: 1200mm working pressure: 10mpa
Coil Width (Max.): 500mm
Working speed: 0-25m/min
Power: 5.5KW

2) Feeding and leveling system

Feed the coil into to guide wheel (can right and left adjust)

Leveling is three roller above and four roller below, quenched and chrome coated 0.05mm

3) Punching system(adjustable)

Hydraulic punching

Oil cylinder dia: 140mm

Working pressure: 20mpa

Mould material: Cr12 quenched 58°-62°

Hydraulic power: 7.5kw

4) Roll forming machine

Main motor power: 37kw

Total weight: About 15tons

Drive: Gearbox driving with universal joint

Main shaft dia: 100mm material: 45 forge steel

Roller material: GCR15 quenched 58°-62°, chrome coated 0.05mm

Roll station:16stations

Raw material: Black steel and galvanized steel, thickness: 2.5-3mm

Line speed: 10m/min

PLC: Panasonic, made in Japan 380V 50HZ

Computer operating panel: Touching screen

5) Cutting system

Hydraulic cutting

Blade material: Cr12,quenched 58°-62°

Oil cylinder dia: 250mm

Working pressure: 30mpa

Components

Machine pic

Profile drawing

Installation

(1) If installation is needed, we will dispatch technician to the buyer's factory abroad to assist regulating the machine with charge free. The buyer should assist Liming to get the Chinese technician's visa and should pay for the roundtrip air ticket and the local accommodation.

(2) If installation is needed, the buyer shall make the following preparation before arrival of technicians.

a) Position the machine in the buyer's factory.

b) Prepare necessary electric wiring.

c) Prepare material of trial running.

d) Provide labors for assistance and installation during installation.