Active Member
|
[China]
Address: Haoyue science and technology park, No.1 Fangyuanzhong Road, Jiangning District,Nanjing City,Jiangsu Province, China.211102
Contact name:
|
|
|
|
M12 Hall Proximity Sensor , Gear Speed Sensor For Hydraulic Motor
Quick details:
Name: M12 Hall effect gear speed sensor
Output power: 12-30VDC
Output signal:pulse
Frenquecy range: 0-18000 Hz
Specification:
| Name | M12 hall effect gear speed sensor |
| Setting range(rpm) | 0-18000 |
| Output electric | NPN/PNP , NO/NC. |
| Output power | 12-30Vdc |
| Output signal | pulse |
| Output voltage | 400mA |
| Frequency range | >100 kHz |
| Sensing distance | 1.5mm |
| Short-circuit protection | pulsed |
| Reverse polarity protection | yes |
| Voltage drop [V] | < 2.5 |
| Current consumption [mA] | < 15 |
Damping frequency (max.) [pulses/min] | 18000 |
| Correction factors | mild steel = 1 / stainless steel approx. 0.8 / brass approx. 0.5 / Al approx. 0.4 / Cu approx. 0.3 |
| Hysteresis [% of Sp] | 10 |
| Start-up delay [s] | 0-15 |
| Switching function | output is switched during the start-up delay and if (f actual) is greater than (f preset) |
| Adjustment of the switch point | Teach function |
| Operating temperature [°C] | -30℃~120℃ |
| Protection | IP67 |
| Housing material | stainless steel (320S31); PBT |
Function display Switching status LED | Yellow |
| Operation LED | green |
| Input pulses LED | green |
| Connection | Cable, M12 connector |
| Remarks | *) factory setting **) switching output / pulse output; 250 / 15 mA when used outside the ATEX area ***) only in conjunction with the impact protective housing ****) -20...60°C when used outside the ATEX area |
| Accessories (included) | impact protection housing, 2 lock nuts |
Working Principle:
Before using make sure the gear is mounted on the shaft for speed
measurement traight, Helical or Grooved disk gear all can be used
ount the sensor on the bracket, Adjust the Clarence between the
sensor and the gear tooth to be approx. 1mm. When the gear starts
rotating with the shaft, According to the principle of
electromagnetic induction, a voltage pulse signal is generated at
both ends of the internal coil of the sensor, The Z-voltage pulse
signal is generated when the axis is rotated, According to the
type. flush
Given that NPN= Measured shaft speed in Rotation/Minute, Z=ber of
gear teeth.
When the gear tooth number is 60, the rotation of the axis is
converted to a voltage pulse signal with frequency of f, and the
signal is sent to the corresponding digital speed.
Features:
1) Digital Output Signal
2) Gear Tooth Sensing Capability
3) No Rotary Orientation Concerns
4) Operation Temperature from –30°C to 125°C
5) Short Circuit Protection
6) Zero Speed Operation
7) High Speed (15kHz) Operation
8) 12-36 VDC Operation
9) Nickel plated, Brass housing
