CP5555 6 Pots Brake Caliper With 362*32mm Drilled Disc For EVO8

6 Pots Brake Caliper CP5555 With 362*32mm Drilled Disc For EVO8

How to distinguish between the left and right of the caliper: first, according to the working principle of the piston, the output of the piston is small first and then large, which is consistent with the rotation direction of the brake disc. Secondly, it is required to connect the steel roar surface The caliper logo is outside, and finally ensure that the drain nozzle is upward.

How to distinguish between left and right brake discs: first, look at the ventilation slot structure. There are three kinds of structures: 1) honeycomb type, 2) straight type and 3) oblique type. Honeycomb type and straight type, these two ventilation grooves do not distinguish the direction, and the brake disc only needs to distinguish the left and right according to the brake surface pattern; Oblique type: distinguish the left and right according to the direction of the ventilation slot. The ventilation slot should be in the direction of the rotation of the disc, so as to throw out the heat in the disc and the shaft head through the ventilation slot and achieve good heat dissipation effect. Never install the disc ventilation slot in the opposite direction.

There are many ways to empty: 1 Traditional foot stepping: start the engine, one person sits in the driver's seat and step on the brake, and one person cooperates to drain the oil from the brake cylinder in turn (traditional name: step on, step on, OK. Continue to step on, step on, ok...). 2. Pneumatic pumping type.

The steps for installing brake pads are:

01. First jack up the car, then loosen the handbrake and loosen the bolts of the car tire

02. Remove the tire, expose the brake disc and brake caliper of the car, and remove the brake caliper;

03. The brake caliper cannot be separated as a whole and needs to be suspended or placed on a high platform;

04. Open the brake oil box at the engine exit, then remove the worn brake pads and install the new brake pads as they are

05. Reinstall the brake caliper, install the tire, remove the jack, pull on the car's hand brake and complete the replacement of the brake pad.

The working principle of braking mainly comes from friction. The friction between brake pads, brake discs (drums) and tires and the ground is used to convert the kinetic energy of the vehicle into heat energy after friction and stop the vehicle. A set of good and efficient braking system must provide stable, sufficient and controllable braking force, and have good hydraulic transmission and heat dissipation capacity, so as to ensure that the force applied by the driver from the brake pedal can be fully and effectively transmitted to the power pump and each sub pump, so as to avoid hydraulic failure and brake recession caused by high heat.

FAQ

Q: Which countries are your products mainly sold to?

A: We maniny sell to Europe, UK, USA, Southeast Asia