Jinan Lijiang Automation Equipment Co., Ltd. |
Verified Suppliers
|
|
Insulating glass sealing has stable performance and powerful function
Application
Automatic sealer for insulating glassAbnormal situations occur and
are handled
Shooting the emergency stop button will cut off all control of the
system when there is an emergency and when there is an abnormal
situation! For the wrong action or non-action caused by some
abnormal signals during the gluing process, please take the
emergency stop button for processing or hold down the alarm reset
button on the touch screen for 5S before initiating the device or
reenergizing the device for further operation.During the gluing
process, no one is allowed to enter the close range of gluing to
avoid injury.Do not use hand or other tools to approach any sensor
of the device during the gluing process to avoid
misoperation.Unloading in automatic operation must be carried out
in the lower section (the end). It is forbidden to remove the
coated glass from the discharging section (the middle).If the
machine is stopped after gluing, cleaning must be done to prevent
the black glue from solidifying in the mixer. Wait until the
extruded glue is completely white to stop; Note: wait until the
very clean white glue comes out!Pay attention to keep the equipment
clean, especially the glue nozzles and transfer belt.
After gluing begins, adjust according to the corresponding parameters to make the machine achieve better gluing effect.After gluing, enter the cleaning mode. At the operation panel, press the cleaning button to start. The light will turn green until the white glue A is discharged. Press clean to close, after mixing glue pressure relief, the head automatically rotate 0 degrees, and then shut down.Enter the bar width in the following list and the machine will automatically call the parameters based on the bar width.Set the glue base speed, the larger the parameter, the faster the glue speed.Glue reference depth: the default is 5mm, easy for system calculation, do not modify.Glue base width: the default is 9mm, which is convenient for system calculation. Do not modify.Two-cavity reference width: the default is 9mm, convenient for system calculation, do not modify.The saturation of each edge refers to the single-side adjustment of the speed without changing the base speed and the pressure of the hydraulic station.Enter the glass length. If you are online, you do not need to enter the glass length.In the pressure screen of the hydraulic station, input the pressure, 3-10mpa, and then point the pressure to determine. Set the pressure.After everything is ready, begin to glue the glass, in the glue process, is to rely on the scanner to control the amount of glue. The steps to calibrate the scanner are as follows.Then enter the current detector value at the opening time of detector 3, and the maximum depth value of detector 4 is 18, with the position between 0 and 18mm.
Max.glass size | 2500mm |
Min.glass size | 170mm*400mm (2000mm machine) |
Glass thickness | 12-56mm |
Working speed | 5-40m/min |
Air pressure | 0.6-0.8MPa |
Squeeze pressure | <350kg/m³ |
Plane angle | 6°- 9° |
Max glass weight | 400kg |
Voltage power | 380V 12kw |
Overall dimension | 8700mm*2000mm*3500mm |