8965 one-component polyurethane adhesive is a one-part, black, fast-curing, low odor
polyurethane adhesive. After curing, the adhesive layer is an
elastomer, which has good resistance
to cold and heat changes, and resistance to stress changes.
Suitable for gluing with pneumatic glue
gun or mechanical gluing, short positioning time and easy
applicaton.
How to use
Cleaning: Clean the surface to be bonded,remove rust, dust, water
and oil. Glue: Cut a suitable small hole on the tip of the glue
barrel, the inner diameter of the mouth of the
glue nozzle should be determined by the glue application width, put
it into the glue gun and start
the glue application operation. Primer:It needs to be used with
Huitian designated activator and primer. The time for the primer
to wait for volatilization and drying is usually 10-30 minutes. The
specific time depends on the
ambient temperature at that time. After the primer is volatilized
and dried, the glue is applied. Cure: The temperature and humidity
of the environment have a great influence on the surface
drying and curing of the polyurethane adhesive. If the temperature
is too low, the curing will be
slower; if the temperature and humidity are too high, the surface
drying will be faster. The best operating environment conditions
are: temperature 20～30℃, humidity 50～70%RH;please operate with
caution beyond the range of temperature 5～35℃ and humidity
35～75%RH. During the sizing and curing process of polyurethane
adhesive, avoid contact with chemicals
containing hydroxyl and amino groups, which will cause the
polyurethane adhesive to not cure or
cure incompletely. Storage:Unused glue should immediately tighten
the cap and seal the nozzle for storage. When
using it again, if there is a little crust on the seal, it can be
removed without affecting normal use. During storage, there may be
a small amount of crust on the mouth of the nozzle, which can be
used normally after removal without affecting the performance of
the product.
8965 One component pu sealant adhesive was well accepted by many
OEM , High performance and fast positioning !
