Yaskawa Electric High Speed Servo Moto54.7a Amp 200v-ac 7.5kw 48nm
Servo Motor SGMGV-75A3A6C
Configuration:
Current: 54.7A
Volatge: 200V
Power :7.5KW
Rated Torque: 48N-m
Max speed: 1500rpm
Encoder: 17bit Absolute encoder
Load Inertia JL kg¡m2¢ 10−4: 0.026
Shaft: straight without key
OTHER SUPERIOR PRODUCTS
Yasakawa Motor, Driver SG- Mitsubishi Motor HC-,HA-
Westinghouse Modules 1C-,5X- Emerson VE-,KJ-
Honeywell TC-,TK- Fanuc motor A0-
Rosemount transmitter 3051- Yokogawa transmitter EJA-
Contact person: Anna
E-mail: wisdomlongkeji@163.com
Cellphone: +0086-13534205279
Similar Products
SGMGV-05ADA21 |
SGMGV-09ADA61 |
SGMGV-09ADC21 |
SGMGV-09ADC61 |
SGMGV-13ADA21 |
SGMGV-13ADA61 |
SGMGV-13ADA6C |
SGMGV-1AADA61 |
SGMGV-20ADA21 |
SGMGV-20ADC61 |
SGMGV-30ADA21 |
SGMGV-30ADB6C |
SGMGV-30ADC61 |
SGMGV-44ADA21 |
SGMGV-44ADA2C |
By NEMA definition, two-digit frame numbers are fractional frames
even though 1 HP or larger motors may be built in them. Three-digit
frame numbers are by definition integral frames. The third numeral
indicates the distance between the mounting holes parallel to the
base. It has no significance in a footless motor. A summary of NEMA
standard dimensions is on the facing page.
C = NEMA C face mounting (specify with or without rigid base)
D = NEMA D flange mounting (specify with or withoutrigid base)
H = Indicates a frame with a rigid base having an F dimension
larger than that of the same frame without the suffix H. For
example, combination 56H base motors have mounting holes for NEMA
56 and NEMA 143-5T and a standard
NEMA 56 shaft
J = NEMA C face, threaded shaft pump motor
JM = Close-coupled pump motor with specific dimensions and bearings
JP = Close-coupled pump motor with specific dimensions and bearings
M = 63/4” flange (oil burner)
N = 71/4” flange (oil burner)
T,TS = Integral horsepower NEMA standard shaft dimensions if no
additional letters follow the “T” or “TS”. TS = Motor with NEMA
standard “short shaft” for beltdriven
loads.
Y = Non-NEMA standard mount; a drawing is required to be sure of
dimensions. Can indicate a special base, face or flange.
Z = Non-NEMA standard shaft; a drawing is required to be sure of
dimensions.