High Temperature Liquid Vortex Flow Transmitter Up To 350℃ Good Medium Generality

                                                          High Temperature Vortex Flowmeter up to 350℃ for Liquid
 
1. Introduction

LUGBML is based on vonkarman's vortex principle and uses piezoelectric crystal as the test element. It is a new vortex flowmeter for stress detection. It has the advantages of large range ratio, high precision, small pressure loss, good medium universality, direct ratio of pulse output to flow rate, and easy connection with computer, etc. Because the probe and vortex generator of the sensor are installed separately, the high temperature resistant piezoelectric crystal does not contact the instrument, and its structure is simple, with good universality and high stability. LUGBML series vortex flowmeter sensors can be used to detect and measure the flow of various gases, liquids and vapors. It can be used with ML6000 series vortex flowmeter of our company. It can also be combined with computers and temperature, pressure and density sensors to form a high-precision mass flow or heat flow detection system.

 
2. Features

• Vortex flow meter structure is simple and strong, no moving parts, good stability.
• Easy to install and easy to maintain.
• The measurement range is wide, up to 10:1.
• As required to compensate for the amount of fluid, there is no need to recalibrate the gauge factor after replacing the attachment

 
3. Specifications

1) Measuring medium: Steam,gas, liquid(Avoid of multiple- direction fluid)

2) Accuracy:Liquid:1.0% Gas:1.5%

3) Repeatability:Liquid 0.33% Gas:0.5%

4) Range:Liquid:0.7m/s~7m/s Gas:7m/s~40m/s

5) Working pressure:Standard 1.6MPa,2.5~4.0 MPa (on request)

6) Fluid temperature:-40℃~250℃(Common type)；100℃~350℃(High-temperature type)

7) Body material:304 stainless steel(SS316 is optional)

8) Output signal:Pulse(three wires,low level≤1V;High level≧4V);4~20mA;RS485

9) Power supply:24VDC(12VDC),Lithium battery

10) Ambient temperature : -35 ℃ ~ 60 ℃ ( without LCD ); -5℃~60℃(with LCD)

11) Relative humidity:5~95%

12) Protection level:IP65

13) Electrical connection:M20*1.5

 
4. Design & Installation

The installation instrument is very important, if the installation is not good, it will affect the accuracy, service life and damage.

1. to avoid strong, high-frequency, high-power switching groups, instrument power supply should be avoided close to these equipment.

2. avoid high temperatures and radiation sources. If installation is required, heat insulation and ventilation measures should be taken.

3. to avoid high temperature and enchanted gas, ventilation measures should be taken if installed.

4. eddy current Flowmeter should avoid installation in the pipe sloshing part. If it must be installed on it, the clamping device and the vibration pad located at 2 D should be added to strengthen the shockproof. Instruments are best installed indoors, outdoor installation attention to waterproof, special attention to the joint, so that the cable wire into a U shape, to avoid water into the amplifier body, installation should save enough space, in order to install the connection line and daily maintenance.

5. Details