PIC16F1764-E/ST Microchip 8-bit Microcontrollers - MCU 7KB Flash 512 RAM 10bit DAC

           PIC16F1764-E/ST Microchip 8-bit Microcontrollers - MCU 7KB Flash 512 RAM 10bit DAC

1.Description
The PIC16(L)F1764/5/8/9 family offers intelligent analog with digital peripherals to create up to two independent closed-loop channels. These 14 and 20-pin devices enable the ability to interconnect the on-chip peripherals to create customfunctions specific to each application; helping simplify the implementation of a complex control system and givedesigners the flexibility to innovate

2.Core Features
• C Compiler Optimized RISC Architecture
• Only 49 Instructions
• Operating Speed:- DC – 32 MHz clock input- 125 ns minimum instruction cycle
• Interrupt Capability
• 16-Level Deep Hardware Stack
• Up to Four 8-Bit Timers
• Up to Three 16-Bit Timers
• Power-on Reset (POR)
• Configurable Power-up Timer (PWRT)
• Brown-out Reset (BOR) with Selectable Trip Point
• Extended Watchdog Timer (EWDT):- Low-power 31 kHz WDT - Software-selectable prescaler- Software-selectable enable

Memory
• Up to 14 Kbytes Flash Program Memory
• Up to 1024 Bytes Data RAM Memory
• Direct, Indirect and Relative Addressing modes
• High-Endurance Flash (HEF):- 128B of nonvolatile data storage- 100K erase/write cycles

Operating Characteristics
• Operating Voltage Range:
- 1.8V to 3.6V (PIC16LF1764/5/8/9)
- 2.3V to 5.5V (PIC16F1764/5/8/9)
• Temperature Range:
- Industrial:-40°C to +85°C
- Extended:-40°C to +125°C

eXtreme Low-Power (XLP) Features
• Sleep mode: 50 nA @ 1.8V, typical
• Watchdog Timer: 500 nA @ 1.8V, typical
• Secondary Oscillator: 500 nA @ 32 kHz
• Operating Current:
-8 A @ 32 kHz, 1.8V, typical
-32 A/MHz @ 1.8V, typical
• Low-Power BOR (LPBOR):
- 200 nA in Sleep

Digital Peripherals
• Configurable Logic Cell (CLC):
- Up to three CLCs; up to four selected inputs
- Integrated combinational and state logic
• Up to Two Complementary Output Generators (COG):
- Push-Pull, Full-Bridge and Steering modes
• Up to Two Capture/Compare/PWM (CCP) modules
• Pulse-Width Modulators (PWM):
- Up to two 10-bit PWMs
- Up to two 16-bit PWMs
• Peripheral Pin Select (PPS):
- Configure any digital pin to output
• Serial Communications:
- Enhanced USART (EUSART)
- SPI, I2C, RS-232, RS-485, LIN compatible
- Auto-Baud Detect, auto-wake-up on start
• Up to 18 I/O Pins:
- Individually programmable pull-ups
- Slew rate control
- Interrupt-On-Change (IOC) with edge select
• Up to Two Data Signal Modulators (DSM)

Intelligent Analog Peripherals
• 10-Bit Analog-to-Digital Converter (ADC):
- Up to 12 external channels
- Conversion available during Sleep
• Up to Two Operational Amplifiers (OPA):
- Selectable internal and external channels
• Up to Four Fast Comparators (COMP):
- Up to five external inverting inputs
- Up to eight external non-inverting inputs
- Fixed Voltage Reference at non-inverting input(s)
- Comparator outputs externally accessible
• Digital-to-Analog Converters (DAC):
- Up to two 10-bit resolution DACs
- Up to two 5-bit resolution DACs