Europe Standard Waste Light Oil Burner For Industrial Boiler Environment Protecting

Europe standard waste oil burner for industrial boiler with best price

A waste oil burner is a common industrial device that uses chemical combustion to convert fuel into heat. The waste oil burner generally consists of a burner casing, a program controller, a fan, an oil pump, a servo motor, an electric eye, a solenoid valve, a combustion head, and the like. It is fuel. Important auxiliary equipment for gas boilers is also widely used in technical heat treatment, drying, baking, drying, incineration and other related fields.

The working process can be briefly described as follows: After starting up, the program controller outputs a current signal and the fan starts running. The servo motor drives the damper to perform pre-blowing. After completion, the servo motor drives the damper back to the ignition position. At this point, the ignition transformer starts to output a high-voltage ignition action, and the solenoid valve is simultaneously opened. If the ignition is successful, the program controller will adjust the load according to the heat demand. If the ignition fails, the program will issue a prompt to prepare for the next start.

Waste oil burner features:
1. Waste oil burner
2. Single stage operation (on/off)
3. High pressure mechanical atomisation of fuel using nozzle.
4. Ability to obtain optimal combustion values by regulating combustion air and blast-pipe.
5. Manual flow adjustment.
6. One flange and one insulating seal for boiler fastening.
7. Combustion air intake with flow adjustment device.
8. Sliding boiler coupling flange to adapt to head protrusion of the various types of boilers.
9. Adjustable blast-pipe with stainless steel nozzle and deflector disk in steel.
10. Mono-phase electric motor to run fan and pump.
11. Flame pressure check by photo-resistance.
12. Electrical plant protection rating lp40.

Waste oil burner structural features:
1. The waste oil burner is a self-contained structure. The motor drives the blower impeller and the oil pump through the same shaft. All adjustment devices are visible and easy to operate.
2. The flame of the burner can be completed by adjusting the amount of oil and the amount of wind;
3. The waste oil burner flame adjustment mode includes two modes: sliding adjustment and proportional adjustment;
4. The waste oil burner controller can control the autonomous operation of the equipment and monitor the flame;
5. The waste oil burner's special structural design can be operated in an indoor environment of -10 ° C —40 ° C.

Waste oil burner data sheet.

Waste oil burner manufacturers with famous part ,long life time:
SIEMENS CONTROLLER
DUNGS VALVE
DANFOSS NOZZLE
SUNTEC OIL PUMP
BRAHMA/PARKER SOLENOID VALVE
FIDA TRANSFERMA
SIEMENS SERVOMOTOR