Active Member
|
[China]
Address: 2# Jinlong Rd. Baolong Industrial Zone, Longgang Dist. Shenzhen China 518000
Contact name:Tarik Lu
Forsentek Co., Limited |
|
|
Reaction torque measurement device flange mounted torque measure equipment
High capacity flange to flange reaction torque sensor FT03 is made
of high stiffness alloy steel based on strain gauge
technology,torque transducer FT03 delivers mV/V signal from
wheatstone bridge bonded on a specially machined body.Flange to
flange design makes it easy to mount FT03 to existing
strutures.Torque meter FT03 is available in a very wide
measuring range from 200NM up to 100kNm,you may find FT03 suitable
for applications such as motor torque measurement,test bench applications,screw driver
calibration,fatigue testing,twist measurement,motor
dynamometers,actuator test as so on.Model FT03 can be modified or
customized to meet requirements of different applications.
Dimensions
Specifications
| Capacity | 200NM 300NM 500NM 1000NM 2000NM 3000NM |
| Rated output | 1.5mV/V |
| Excitation | 3-15V |
| Zero balance | ±0.05mV/V |
| Nonlinearity | 200NM~10kNM: ±0.25% R.O. |
| Hysteresis | 200NM~10kNM: ±0.25% R.O. 20k~10kNM: ±0.5% R.O. |
| Nonrepeatability | 200NM~10kNM: ±0.1% R.O. 20k~10kNM: ±0.2% R.O. |
| Creep(10min) | ±0.1% R.O. |
| Safe overload | 150% F.S. |
| Ultimate overload | 200% F.S. |
| Compensated temperature | -10...+40oC |
| Operating temperature | -20...+60oC |
| Temperature shift zero | ±0.02% R.O./oC |
| Temperature shift span | ±0.02% R.O./oC |
| Input resistance | 700±100 ohms |
| Output resistance | 700±10 ohms |
| Insulation resistance | >5000M ohms |
| Ingress protection | IP50 |
| Material of element | Alloy steel |
| Cable | Ø5*3000mm 4-core shielded |
| Wiring code | Red--Excitation+ Black--Excitation- Green--Signal+ White--Signal- |
A torque sensor is a transducer that converts mechanical torque
into mV signal proportional to the applied torque.The acting
torsion causes deformation of the measuring element,the bonded
strain gage deforms accordingly which will cause the resistance
change of the wheatstone bridge,under constant power supply, the
output signal between Sig+ and Sig- will change proportionally,thus
the moment can be measured by measuring the output signal from the
transducer.The output range of FT03 is normally within
-20mV...+20mV, signal amplification may be required for most
applications, a signal conditioner can be used to get -5~5V, 0-10V
or 4-20mA output for easy data processing.
