high performance Downstream Extrusion Equipment Planetary Cutter 7-20s cutting cycling

Downstream Extrusion Equipment Planetary Cutter

Summary:

The device consists of guide rail fixing frame, moving frame and rotary assembly, clamping mechanism and dust absorption mechanism.

The moving frame can move back and forth in the guide rail fixing frame under the action of the moving cylinder.

To realize the edge cutting pipe edge with the pipe moving together.

The rotary assembly is fixed on the wall board of the moving frame by two sets of rollers (4 for each set). The rotary assembly is driven by the motor, reducer and sprocket for revolution relative to the moving frame.

Rotary assembly installed on the feed mechanism assembly, cutting mechanism assembly.

The feed mechanism assembly drives the screw rod to move by the motor, and the connecting rod is pulled by the bolt on the screw rod to make the saw blade and milling cutter advance and retreat in the cutting assembly, and complete the action of advance and retreat.

The bracket fixed on the feed motor is equipped with a stroke switch to determine the size of the feed;

A limit stroke is installed on the bracket to protect the position of the maximum stroke, and the PLC time control is used for automatic tool withdrawal.

Cutting mechanism is composed of motor, intermediate pulley, cutting tool, etc., whose function is to complete rotation and cut plastic pipe.

The clamping mechanism is fixed on the moving frame, which is composed of clamping cylinder, clamping hafu, guiding column, bracket and so on.

The function is to clamp hafuran and hold the plastic pipe tightly when the cutting signal arrives, so as to make the moving frame move at the same speed as the pipe production speed and ensure the normal cutting process of the cutting machine.

Turn on the power, turn on the knob to adjust the position, close the circuit breaker in the electric box, enter the touch screen, manual button, and press the rotation button of the blade. If the direction of steering is consistent with the sawblade's sawtooth, the steering of other motors of the whole machine is correct (the factory has set it), otherwise the machine cannot operate normally.

(remember: such as rotation, reversal, advance and retreat stroke will be lost, and damage the machine).

Meanwhile, press 0.5~ 0.6mpa air source.

Cutting machine operation process is that when cutting signal to the programmable controller, the clamping cylinder for clamping mechanism under the effect of electromagnetic valve movement, ha cefuroxime hold pipe material, because this device before and after the two roller has adjust the center of the pipe, as a result, two clamping the pipe center of clamping the same, then the entire mobile frame under the impetus of the transfer cylinder and steel tubes and pipe constant moving forward, while the feed mechanism and the mechanism of rotary assembly, start at the same time, the cutter institutions to set position after stop movement, revolution of the motor starting at this moment, the motor with frequency converter, the worm gear reducer reducer, the pulley will force to the pinion,

The pinion drives the big gear to turn, so that the rotary assembly makes a revolution movement, revolution one week, revolution motor stop, motor reverse back to the set position.

(the position is set by the programmable controller and the time is seconds) the rotation motor stops, the clamping mechanism is loosened, and the return cylinder drags the moving frame back to the starting position.

The running time can be set according to the diameter of pipe.

The whole cutting action can be realized by manual and automatic two states.

The function of the dust collecting mechanism is to absorb cuttings and prevent pollution of the working environment.