Active Member
|
[China]
Address: 189# Longzhen Road,Cixi City,Ningbo,Zhejiang Province,China
Contact name:Kevin
Ningbo FET Building Materials and Technology Co.,Ltd |
|
|
Acid and Alkali Resistance Fireproof A1 Class Compressed Fiber
Cement Board Wall Siding Heat Insulation
Product Introduction:
Fiber cement board is a composite material made of sand,cement and
cellulose fibers. Fiber cement board is manufactured in a sheet
form and is used not only as cladding but also commonly used as an
eave lining and as a tile underlay on decks and in bathrooms and
other places.
Product | Fireproof Fiber Cement Board |
Dry Density(g/cm3) | 1.2-1.3 |
Water absorption (%) | 33-40 |
Wet expansion (%) | 0.25 |
Water Content(%) | 13-20 |
Bending Strength(Mpa) | 9-16 |
| Shrinkage rate(%) | 0.15-0.2 |
Frost resistant | No delamination and crack after 25cycles under freezing and thawing |
| Water penetration | No water drop on the board surface after 24hours |
Product Application:
(1). Interior&exterior wall&Furred ceiling
(2). Insulation materials&Flooring&Road barrier
(3). Sound-adsorbing wall & Suspended ceiling
Main Features:
1. 100% Asbestos Free
2. Excellent Fire Resistant
3. Excellent Moisture / Water Resistant
4. Good Heat and Sound Insulation
5. High Strength
6. Stable Dimensions
7. Durability and long service life
Packing:
1. Strong wooden pallet(Standard Export Package)
2. Corner protective
3. Plastic Film
4. Protect Board
(1). Thickness: 4-25mm
(2). Standard size: 1220*2440mm or 1200*2400mm
(3). Note: other specification is available
Installation methods:
1. We draw the installation guideline to define the fixing
position, the center distance is 1200mm.
2. USe UC type keel hang fitting to link and fix the room and key
keel, keep the key keel horizontal.
3. Use the caliper to vertically fix the sub keel on key keel,the
center distance of the sub keels is 611mm.
4. TO install the horizontal keels as per the request,is center
distance is 1222mm.
5. Use the tapping screw fix the woersen board on the sub-keel and
do the treatment of the seam connection.
Lofting lines
Use shoot nails or rivet screws to fix the joint frame in follow
and top slab
Arrange vertical keel according to the design requirement, and then
install the horizontal keel
Cut the board into right size
Fix the board on the keel with self-drilling screw by the way of
offset joints. Ths space between two tapping screw is generally
about 200~250mm, and screw need to sink into the board for 0.5 mm
Please keep 4mm expansion joint between two board
It should be fixed from center to around while sealing the board,
do not multiple-point work at the same time so as to avoid making
the board deformed
Before the board packied,in order to strengthen the effect on sound
insulation and fire-proofing, you can put some glass wool
