CE FFP1 Valved Respirator Mask ,Activated Carbon Dust Mask
,Non-Woven Polypropylene
1 . Material of each layer
- EN149: 2001 +A1: 2009. Respiratory protective devices. Filtering
half masks to protect against particles. Requirements, testing,
marking.It complies with European Regulation (EU) 2016/425 on Personal
Protective Equipment (PPE).Category III.
- EU type examination certificate (module B) issued by BSI , notified
body n°0086.The PPE is subject to the conformity assessment procedure based on
internal production control plus supervised product checks at random intervals (Module C2) set out in Annex VII under
surveillance of BSI , notified body n°0086.
Outer layer : Protective pp spun-bonded non-woven
Middle layer : FFP2 melt blown filter(have filter efficiency level
of 80%)
Middle layer :Active Carbon filter (MX-2008)
Inner layer : Shaped needle punched cotton
2 . Descriptions
MX-2008 FFP1V Dust Mask with two head-straps provides comfortable
& secure seal,nose clip individually adjustable nose clip for
excellent fit.
In compliance with the norm EN 149:2001+A1:2009 ,PPE III CATEGORY
and Shell-shaped
3 . Mask CE Quality Standards
CE Standard for Disposable Respirators |
EN: 149:2001 + A1:2009 |
Distinguish | Filter Efficiency | Penetration | Resistant |
FFP1 NR | ≧80% | < 20% | < 21mmH2O |
FFP2 NR | ≧94% | < 5% | < 24mmH2O |
FFP3 NR | ≧99% | < 1% | < 30mmH2O |
4 . How to use?
- The mask is for single use only.
- The mask should not be removed from its packaging until its
required for use.
- Use the respirator in accordance with applicable health and safety
regulations.
- Fit the respirator and check leak-tightness before entering the
contaminated area.
- Wear the respirator for the whole duration of exposure to
contaminants.It should not be used for more than 8 hours
continuously and should be discarded after use.
- Transport and stockage of unused masks should be such that the
product is not stored in direct sunlight and in frost free
conditions,not in contact with solvents and cannot be damaged by
physical contact with hard surfaces/items.
- As required by European Health and Safety requirements,the user is
advised that when the mask is in contact with the wearer’s skin,it
may cause allergic reaction to susceptible individuals.If this is
the case,leave the hazard area,remove the mask and seek doctor’s
advice.
5. Warning
- The user should be trained in the fitting and should be aware of
the instructions for using prior to donning the respirator.
- Use in adequately ventilated areas,which are not deficiency of
oxygen.
- Do not use this respirator when oxygen concentration is less than
19.5%.
- Do not use the mask in explosive environment.
- The mask must be fitted correctly to ensure the level of protection
expected is achieved.
- The facila hairs or heards and certain facial charactrtistics may
reduce the effectiveness of the mask.
- For mask mark marked “NR”,the particle filtering half mask shall
not be used for more than one shift.
6 . More pictures