Active Member
|
[China]
Address: Room 403, Building 1, No.89 CuiBai Road, Haishu District,Ningbo ,China.
Contact name:Wu
Vican Explosion Proof Technology Co.,ltd |
|
|
BJX series explosion proof junction box 3/4" hazardous location
Description:
The BJX series explosion proof junction box is made of cast aluminum alloy, flameproof structure, the terminal is equipped with terminal blocks or busbars, and internal and external grounding screws are provided for grounding wire connection. Sealing rings, washers and compression nuts are installed in the cable entry device from the inside to the outside for cable and steel pipe wiring. The outer surface of the junction box is electrostatically powder sprayed and resistant to corrosion.
Technical Parameters:
1. Execution standards: GB3836.1, GB3836.2, GB3836.3, GB12476.1, IEC60079
2. Rated voltage: AC 380V/220V/110V/36V/24V
3, rated current: 20A-200A
4, explosion-proof mark: ExeII T6 ExtD A21
5, protection level: IP65
6, anti-corrosion grade: WF1
7. Introduction port specification: G1/2"~G2.5"
| Junction box general size | ||
| EXe(mm) | EXd IIB(mm) | EXd IIC(mm) |
| 135*135*100 | 200*200*130/150 | 200*200*130 |
| 135*200*100 | 200*300*150/180 | 300*300*150 |
| 200*200*100 | 300*300*150/180 | |
| 200*300*150 | 300*400*150/180 | |
| 300*300*150 | 400*500*160 | |
| 300*400*150 | 400*500*200 | |
| 400*500*150 | 500*600*160 | |
| 500*600*200 | ||
| 500*600*250 | ||
| The above dimensions are made of aluminum alloy. If it needs custom-made, it can be Steel plate welding or stainless steel. | ||
Application:
1. explosive atmospheres Zone 1 and Zone 2;
2.combustible dust Zone 21 and Zone 22;
3.IIA, IIB and IIC groups explosive atmospheres;
4.Designed for explosive hazardous locations such as oil refinery, storage, chemical, pharmaceuticals,military industries, etc.
5.Designed for wiring/ branching.
Installation:
When installing, open the junction box cover and the introduction device, select the appropriate inner diameter of the sealing ring according to the outer diameter of the cable, and then pass the cable through the compression nut of the introduction device, the gasket and the sealing ring are connected to the cavity, and fasten. The compression nut seals the cable, the introduction device that does not introduce the cable replaces the cable with a plug, and tightens the compression nut. Connect the wire to the corresponding position of the terminal block, connect the grounding wire, close the cover, and fasten the cover with bolt.
