100m Transmission 100G QSFP28 Transceiver , Cisco 100g Transceiver 100G CFP2 SR10 MPO Connector

PN: CP28510A-3MCD01

Cisco Compatible 100G CFP2 Transceiver 100G CFP2 SR10 850nm 100m MPO Connector

Features

       Ø Supports 103.1Gb/s to 112Gb/s bit rates

Ø Applicable for 100m with OM3 MMF and 150m with OM4 MMF

Ø MPO 24 receptacle optical interface

Ø CPPI electrical interface

Ø Uncooled 10x10Gb/s 850nm transmitter

Ø 10 parallel electrical serial interface

Ø Low power consumption <4W

Ø Digital Diagnostic Monitor Interface

Ø MDIO Communication Interface

Ø Compliant with 100GBASE-SR10

Ø Operating case temperature:

Ø Commerical:0 to 70 °C

Applications

       Ø 100GBASE-SR10 Ethernet

Ø 10x11.2Gb/s Multimode OTN

Ø 10x 10GE-SRLite Ethernet

Standard

Ø Compliant with IEEE 802.3ba

Ø Compliant with CFP2 MSA hardware specifications

Ø Compliant with CFP2 MSA management specifications

Description

100G CFP2 SR10 transceiver modules CP28510A-3MCD01 are designed for use in 100 Gigabit Ethernet links and 10x11.2G OTN client interfaces over multimode fiber. They are compliant with the CFP2 MSA and with IEEE 802.3ba 100GBASE-SR10. Digital diagnostics functions are available via the MDIO interface.

The optical transmitter portion of the transceiver incorporates a 4-channel VCSEL (Vertical Cavity Surface Emitting Laser) array, a 4-channel input buffer and laser driver, diagnostic monitors, control and bias blocks. For module control, the control interface incorporates a Two Wire Serial interface of clock and data signals. Diagnostic monitors for VCSEL bias, module temperature, transmitted optical power, received optical power and supply voltage are implemented and results are available through the TWS interface. Alarm and warning thresholds are established for the monitored attributes. Flags are set and interrupts generated when the attributes are outside the thresholds. Flags are also set and interrupts generated for loss of input signal (LOS) and transmitter fault conditions. All flags are latched and will remain set even if the condition initiating the latch clears and operation resumes. All interrupts can be masked and flags are reset by reading the appropriate flag register.

The optical output will squelch for loss of input signal unless squelch is disabled. Fault detection or channel deactivation through the TWS interface will disable the channel. Status, alarm/warning and fault information are available via the TWS interface.

Quality Control

 Package

Related Products List