ECW-s110 elevator load sensor/elevator load weight sensor

aution: This system is applicable an elevator with「moveable car platform」.Before use, please read the following content carefully.

The Inductive magnet is specially-made rare-earth magnet for this product with strong magnetic force. Special care should be taken during installation. Under no condition should it be away from the high temperature above 100℃ to avoid demagnetizing and the equipment damage and personal hurt from this is beyond our responsibility.

Notice:Our part is just responsible for the products quality in the guarantee period under any condition.

Declaration:Our company reserves the right of changing products for technical improvement and the related technical parameters should be referred to the USER’S GUIDE along with the products.

Product Overview

Product Appearance, Interior Structure and Interface Directions:

Notice on Installation

• Install this device as near as possible to the center of elevator car platform or the original place of elevator overload switch. The system should be installed on the bottom bearing beam of elevator car platform with the inductive magnet adhering to the moveable car platform and the marking surface facing to the inductive point of the weighing device.
• The system supporting frame should be made according to elevator concrete situation with the uneasily deforming material of thickness more than 4mm or with enforcing plate to avoid swaying.

Adjust this device so that the car platform magnet aiming to the center point of its upper section. Meanwhile, assure that the section of this device parallel to that of the magnet.