Heavy Duty Electric Pipe Threading Machine for Steel Pipe 1/4"-4" Hongli SQ100F 1224

Hongli SQ100F 1224 Heavy Duty Electric Pipe Threading Machine for Steel Pipe 1/4"-4"

Description

The SQ100F threader is an electric motor-driven machine which centers and chucks pipe, conduit and rod (bolt stock) and rotates it while threading, cutting and reaming operations are performed.

Threading dies are mounted in self-opening die heads.

An automatic oiling system is provided to flood the work with thread cutting oil during threading operations.

Features

1. An induction motor ensures sound levels well when using.

2. A special capacitor-start / capacitor run motor allows the machine to thread where voltage drop is experienced.

3. ¼”-2” universal Die Head; 2½”-4” receding die head allows cutting of tapered or straight NPT / NPSM or BSPT / BSPP threads.

4. Approved by CSA and CE standards.

5. Reliable and proven for constant professional use for up to 4" pipe threading.

6. Ideal for stationary threading in workshop, on building sites, for repairs and service.

7. 3 shifts of speed, enables the machine always within optimised load.

8. Induction motor together with gearbox+belt, effeciently control the noise level.

Specifications

• Motor: 1500 W induction, 50/60 Hz,single phase.
• Switch: ON/OFF heavy duty switch, foot switch and FOR/OFF/REV switch is optional
• Spindle Speed: 36/20/11 RPM.
• Front Chuck: Hammer type with replaceable rocker action jaw inserts.
• Rear Centering Device: Cam action.
• Oiling System: Through die head, with integral oil reservoir.

Standard Equipment

• Model SQ100F threading machine.
• Self-open die head, 1/4”-2”
• Receding self-open die head, 2 1/2”-4”½”-¾” universal HSS dies set.
• 1”-2” universal HSS dies set.
• 2 1/2”-4” universal HSS dies set.
• Cutter: Capacity: 1/4”-4”(6 mm-100 mm) pipe
• Reamer: Positive-locking, right-hand 1/4”-4”(6 mm-100 mm).

Ordering Information

Accessories

Standard Spares for SQ100F Electric Pipe Threading Machine

Maintenance Instructions

Make sure machine is unplugged from power source before performing maintenance or making any adjustment.

Jaw Inserts

1. Clean teeth of jaw inserts daily with wire brush.

2. Replace jaw inserts when teeth become worn and fail to hold pipe or rod.

NOTE! Replace entire set of jaw inserts to insure proper gripping of the pipe or rod.

Lubrication

Proper lubrication is essential to trouble-free operation and long life of Threader. Grease main shaft bearings every 2 to 6 months depending upon amount of Threader use. Grease fittings are provided on side base, one at each end of shaft. Use a good grade of cup grease.

Machine Storage

Motor-driven equipment must be kept indoors or well covered in rainy weather. Store the machine in a locked area that is out of reach of children and people unfamiliar with threaders. This machine can cause serious injury in the hands of untrained users.

Machine Transportation

1. If machine is on a Stand, a forklift can be used with or without a sling.

2. Once packed, always use a forklift to move the crate.