Pneumatic rock drill-CM350
The V140 heavy duty pneumatic rock drill has the following
technical characteristics:
non-valve design, high power output, high penetration rate, few
components, easy maintenance, high reliability.
Operator panel
The operator panel is located on the rear-left side of the rig,
making it convenient for the operator to monitor the situation and
to maneuver the rig correctly. The rig’s centralized hydraulic and
pneumatic control levers result in safe and convenient operation.
Feed
With the worm gear reducer and Atlas Copco’s patented motor, the
feed mechanism ensures the proper feed and
lifting force. The piston air motor drives the heavy duty
chain,which can provice 13620 N of lifting force and adjustable
feed force.
Wet dust control device
The correct utilization of the wet dust control device can achieve
a good dust reducing result, with lower air consumption.
Hydraulic power pack
The hydraulic oil pump, which is driven by a vane air
motor,provides positioning power.The oil pump, with the AtlasCopco
patented design, ensures the necessary hydraulic power during
operation.
Tramming motor and track frame
Each track frame is driven by a 6.2 kW air motor, with a gear box.
The disk brake is engaged by springs and is released by air
pressure, which works in the same way in the forward and backward
direction.The climbing ability is 26 degrees with dragged
compressor and 32 degrees without compressor.
Technical data CM 350A
Recommended hole range
Hole
range 64
-102 mm
Drill steel
dimensions 2½u8221X- 4”
Rod handling capacity
T38, T45
Hole
depth 15
m 49’3’’
