Novotechnik MUP-080-111

Special features
* analog signal conditioner for
potentiometric linear and rotary
sensors
* basic version with fixed
amplification
* reduced to supply and high
ohmic pickup of the potentiometer
* normalized ouputs 0..10 V
or 4..20 mA
* good linearity
* very low temperatur coefficient
approx. 20 ppm/K
* mounted on DIN rail according
to DIN EN 50022
Applications
Suitable for use with almost
any novotechnik potentiometer
The wiper signal of the connected
potentiometer is
picked up almost loadless by
an high impedant input circuit.
After this it is transformed into
a proportional standardized
output signal (current or
voltage).
The electronics is buit in an
isolated housing. It can be
snapped directly on hat rails
according to DIN EN 50022.
The wide supply range allows
to be supplied from an unstabilized
power supply.
The very good linearity and
temperature drift enable full
use of the excellent properties
of conductive plastic potentiometers.
The potentionmetric
input can be transmitted
across long distances with
minimum disturbances, particularly
when mounted close
to the sensor
Order designations
Type Art.-No.
MUP-080-111 054220
MUP-080-113 054221