Qingdao Shengmei Machinery Co., Ltd |
V-Process Aluminum Casting molding line
Operating steps about v process molding line
1.`The pattern (with vent holes) is placed on a hollow carrier plate
2.A heater softens the .003" to .008" plastic film. Plastic has good elasticity and a high deformation ratio.
3.Softened film drapes over the pattern with 200 to 400 mm Hg vacuum acting through the pattern vents to draw it tightly around the pattern
4.The flask is placed on the film-coated pattern. Flask walls are also a vacuum chamber with the outlet shown at right.
5.The flask is filled with dry, unbonded sand. A slight vibration compacts sand to maximum bulk density.
6.A sprue cup is formed and the mold surface leveled. The back of the mold is covered with unheated plastic film.
7.Vacuum is applied to the flask. Atmospheric pressure then hardens the sand. The vacuum is released, pressurized air is introduced into the carrier and the mold is stripped.
8.The cope and drag assembly form a plastic-lined cavity. During pouring, molds are kept under vacuum.
9.After cooling, the vacuum is released and free-flowing sand drops away leaving a clean casting, with no sand lumps. The sand is cooled for re-use.
Pictures of castings:
Packing: Nude packing and bulk packing
Shipping: If our clients do not have a certain port, we recommend Qingdao.
1. We do not provide sample, because our products are machines which are large and complicated.
2. We do provide special service or customized service, we can design the layout of your workshop.
3. We can send out clients to your place to help your installation and debugging. Engineers are available to go abroad.
1. Q: Is your factory manufacturer or trade company?
A: Our company is manufacture and we have our workshop. We welcome you-- our
dearest friends to come to our company to see our producing line.
2. Q: What is your MOQ?
A: one set.
Qingdao Shengmei Machinery Co., Ltd
Sandy Xue
Any inquiry,pls feel free to contact us.
Fax: 0532- 86158266
Mb:86-15712768581
Skype: xy928618