Tungsten alloy swaged rod

Introduction of Tungsten Alloy swaged rod

The normal tungsten alloy rod after swaging, ultimate tensile strength and hardness would be increased greatly. The ultimate tensile strength of general tungsten alloy rod is 920 MPa, hardness is 25HRC. However, after swaging, the ultimate tensile strength can reach 1200 MPa, hardness is 35HRC. We could even control at 1400 MPa, 40HRC. This type of rod is one of our main products. Usually the composition of this kind of products is 92%WNiFe.

1. Dimension: Diameter≥8.3mm, Length≤700mm

2. Density: 17.0-18.10 g/cm3

3. Composition: W content: 92-95%, W-Ni-Fe

4. Surface: swaged state

Tungsten Alloy Military Swaging Rod Main Properties:

High density

High melting point

Small volume* Excellent hardness

Superior wearing resistance

High ultimate tensile strength

High ductility

High temperature resistance

Low vapor pressure

Appliance of tungsten heavy alloy swaged rod

Tungsten alloy swaging rod can be use in military defense, such as depleted uranium penetrators, bullet, armor piercing, rifle bullet, sniper rifle penetrator, etc.

E: elva(at)northtungsten(dot)com