Active Member
|
[China]
Address: 36# Yuefeng Road Zhangjiagang City Jiangsu Province China
Contact name:JACKY
Zhangjiagang City Stelle Coating Equipment Co.,Ltd. |
|
|
Manual Castings Sandblasting Room Vacuum Sandblasting Chamber Air Sand Blasting For Derusting Remove Paint
Main features:
1. Wide application, Easy to install and use.
2. Customized, Meet your needs.
3. Good stability, Low failure rate (technical maturity, technical precipitation, skilled workers).
4. Exquisite appearance (mature craft).
5. Large factories, Prompt delivery.
6. Strict quality inspection department.
7. Factory direct selling with competitive price.
8. Over 10 years' production experience.
9. Professional design team to serve you.
10. Mainly electrical control system adopts an international brand.
11. CE certificate assures you about our quality.
Principle Introduction:
| No | Comparison item | Honeycomb wind circulation sandblasting room | Traditional mechanical circulation sandblasting room
|
| 1 | Infrastructure
| 0.5-1.2 m or no foundation, low construction cost. . | 2.5-4 m deep pit, high waterproof requirements, foundation construction costs are several times higher than pneumatic recovery.
|
| 2 | Abrasive | Abrasive sorting There is separate sand returning fan. The cyclone separator is used to sort the abrasive. The particle size can be adjusted accurately, and the dust is large.
| There is no separate return sand blower, and the suction pipe is used for vacuuming. The particle size of the abrasive cannot be adjusted, and the air volume of the dust is not easy to be enlarged, and the sprayed abrasive is not uniform;
|
| 3 | The over-all layout | beautiful, the floor space is small, and the installation is convenient. Since all the equipment are connected by pipes, the installation positions of each system can be installed at will according to the site conditions.
| Each transmission system needs to be closely coordinated, it is impossible to change the installation position, the floor space is large, and the maintenance is inconvenient.
|
| 4 | Abrasive accumulation in the sand return system Abrasives | remaining in the sand return system and fewer Abrasives
| remaining in the sand return system, such as screw conveyors, bucket elevators and other equipment will accumulate a large amount of abrasive
|
| 5 | Occupational safety and environmental protection | The overall sand-absorbing and dust-absorbing floor, the wind flow from top to bottom, the dust suppression environment, dust content, visibility, dust emission are better than the national standard.
| Because the underground material needs to be installed with sand conveying equipment, the suction method is generally sucking up. The wind or side suction forms a dusty environment with high dust content, low visibility, and poor working environment.
|
Mechanical recycling reclamation blasting room features:
2.1 Turn on the light and open the door;
2.2 The trolley exits the blasting room and installs the workpiece;
2.3 The trolley enters the blasting room and closes the gate;
2.4 Check the equipment and environmental conditions, and start the dust removal system and recovery system normally;
2.5 The sandblasting personnel enter the room and wear sandblasting protective clothing and connect the breathing filter;
2.6 Start the sandblasting machine, the workers carry out all-round manual sandblasting of the workpiece;
2.7 blowing or cleaning;
2.8 open the door;
2.9 The trolley exits the sandblasting room and unloads the workpiece.
