Active Member
|
[China]
Address: No. 018, Yaojiapo Road., Jinzhou New District, Ningxiang County
Contact name:Spring Huang
Changsha Tianhe Drilling Tools and Machinery Co.,Ltd. |
|
|
Down Hole Hammer DTH bit NUMA125 TK14 HYPER141-400MM-550MM For Water Well Piling Foundation Drilling
The drill bits offered by Tianhe Drilling are manufactured to the most stringent standards, using high quality materials to provide you with a reliable, high performance cutting edge for your drilling equipment.
1. General Size introduction
| Bit Shank | Bit Dia.(mm) | NO.Air | Gauge | Front | Weight(Kg) | Part No. |
| Holes | Buttons | Buttons | ||||
| NUMA125 TK14 HYPER141 | 381 | 4 | 20*Φ19 | 54*Φ18 | 297 | NUMA125--381 |
| 406 | 4 | 20*Φ19 | 58*Φ18 | 311 | NUMA125--406 | |
| 431 | 4 | 20*Φ19 | 64*Φ18 | 324 | NUMA125--431 | |
| 445 | 4 | 24*Φ20 | 72*Φ18 | 334 | NUMA125--445 | |
| 470 | 4 | 24*Φ20 | 80*Φ18 | 347 | NUMA125--470 | |
| 495 | 4 | 24*Φ20 | 88*Φ18 | 710 | NUMA125-495 |
2. Bit Face Shape Selection:
1. Drop Center Bit
----For high penetration rates in soft to medium hard and fissured rock formations.
2. Concave Face
----The all-around application bit face specifically for medium hard and homogeneous rock formations. Good hole deviation control and good flushing capacity.
3. Convex Face
----For high penetration rates in soft to medium-hard with low to medium air pressures. It is the most resistance to steel wash, and may reduce theload and wear on the gauge buttons, but poor hole deviation control.
4. Flat Face Bit
----This kind of face shape is suitable for hard to very hard and abrasive rock formations in applications
with high air pressures. Good penetration rates an resistance to steel wash.
3. Carbide Button Shape Selection:
1. Semi-Ballistic Buttons
2. Ballistic Button
3. Spherical Button
4. Two-step Button
4. Photos
