Wear Resisting Rubber Lined Single Suction Centrifugal Pump For Fine Particle

6 / 4 R Wear-Resisting Rubber Lined Centrifugal Slurry Pump For Fine Particle

Main introduction of slurry pump

The slurry pump is a single-stage single-suction, cantilever, horizontal centrifugal slurry pump. This type of pump has a thick bearing and is equipped with a heavy-duty bracket, so it is suitable for conveying strong abrasion, high concentration slurry or low concentration high lift slurry. It can be used in multiple stages in series within the range of the pump's large allowable working pressure. The pump can also be used to transport a corrosive slurry.

The slurry pump has a replaceable rubber lining and the impeller is made of rubber. The shaft seal can be a packing seal or a centrifugal seal. The pump's discharge port can be installed at a different angle from 45°C and rotated at eight different angles.

Model meaning 

6 / 4 E - R

6------------Suction diameter(Inch)

4------------Discharge diameter(Inch)

E-----------Support type

-------- Pump Model

R-----------Natural Rubber

Specifications

Typical Applications:

Ash Handling

Cyclone Feeds

Pulp and Paper

Abrasive Slurries

Coal Preparation

Mineral Processing

Aggregate Processing

Suction piping system maintenance

1) Check the pump inlet pipeline for leaks and water leakage, and the pump suction piping system is not allowed to leak.
2) Clean the foreign matter in the feed pool to ensure the particle size of the material to be transported, in line with the particle requirements that the pump can pass, so as to avoid the blockage caused by the large particle material and the fiber material entering the pump.
3) Those who use rubber pumps should pay special attention to prevent sharp solids from entering the pump, so as not to cut the rubber parts and affect the service life of the pump.

Construction Design

Shaft Seal Module Design

Performance table