how to connect tube fitting accurately and securely every time to
make sure it’s safe for you? 1:make sure tube is properly prepared.ensure the tube is clean.
deburred and tube hardness and match the tube fitting specification
. 2:bottom the tube fitting at the back of shoulder on. 3:take the
nuts until can not hand tighten anymore 4:use a marker to mark the
nuts at 6:00, rotate the nuts with a wrench 1 1/4" turn from tight
notice:every user must use the gauge to check the gap between the nuts and
body. when we use the tightening this correctly. this is only one
spot that will give us the max sealing potential for a safe and
sure connection. under tightening cause the ferrules inside not to
bite which can at pressure. release this tube making it become a
projectile. over tightening can crush and damage the ferrules, so
we make sure the nuts it tightened to the precise spot every time. so what can happen if we install a fitting that is over tighten or
under tightened? firstly you may have to throw away the fitting. a tubing run might
have to be replaced which cause a lot of time and expense .also
more concerning it the potential for safely issue. the media
running through our tube maybe at high pressure. it may be high
temperature. it maybe caustic chemicals that can be harmful. so any
time we increase the potential for a leak. we are looking at a
serious consequences. for more question about the tube fitting .please contact us .