Home Companies Shanghai Juyi Electronic Technology Development Co., Ltd

72V DC 3 Phase BLDC Motor Driver 15A Working Current Speed Pulse Signal Output

Contact Us

[China]

Trade Verify

Address: No. 1, lane 1199, yunping road, jiading district, Shanghai,China

Contact name:Lisa

Shanghai Juyi Electronic Technology Development Co., Ltd

Verified Suppliers

Trust
Seal
Verified
Supplier
Credit
Check
Capability
Assessment

72V DC 3 Phase BLDC Motor Driver 15A Working Current Speed Pulse Signal Output

Country/Region	china
City & Province	shanghai shanghai
Categories	Switching Power Supply

Product Details

72V DC,15A working current 3-phase BLDC motor driver for Hall effect BLDC motor

MODEL

OPERATING TEMPERATURE(℃)

OPERATING VOLTAGE(V)

MAX CURRENT (A)

· CONTINUOUS OPERATING CURRENT

(A)

PWM SPEED REGULATION

(1-20KHZ)

ANALOG VOLTAGE SPEED REGULATION (V)

Speed pulse signal output

JYQD-V7.5E

-20—85℃

DC72V

16A

15A

Duty cycle

0-100%

0-5V

√

Wiring diagram

1. Control port

5V —Driver board internal output voltage, external potentiometer or switch for speed adjustment and reversing operation

Z/F —Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V low level or connect to GND is reverse direction.

VR —Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm ,connect with GND when input PWM speed regulation, PWM frequency:1-20KHZ; Duty cycle 0-100%

EL —Enable port control. Connect 5V or no connect to allow operation, connect GND to forbid operation.

Signal— Speed pulse signal output

GND—Used for Drive board internal control

2. Power port

MA ----motor phase A

MB ---- motor phase B

MC---- motor phase C

GND ----DC-

VCC----DC +

3:Hall sensor port

Ha--- Hall a

Hb---Hall b

Hc---Hall c

GND---GND

5V---5V output

4. Use shielded wires if the drivers board has more than 50 cm distance from the motor, otherwise it may lead to abnormal driving, affecting the normal use.

5. Control port distance: 2.54mm,Power port distance:3.96 mm

6. Pay attention to the insulation between the driver MOSFET and the heatsink or the installation plate.

Dimensional drawing

Application guidelines
1.	Confirm that the voltage and power parameters of the motor not exceed the range as specified.
2.	Applicable to hall brushless dc motor with Hall at 120°, not all manufacturers' Hall line sequence are corresponding, you can adjust the Hall line sequence or motor three-phase line sequence according to the actual situation, to achieve the best driving effect.
3.	JYQD-V7.5E is driver board without housing and heatsink, it can drive the motor below 100 watt without any heatsink, but needs normal ventilation.
4.	The 5V output port on the drive board is forbidden to connect external power equipment. It is only applicable to external potentiometer or switch for speed adjustment, commutation and enabling operation