PA25 Type Of Dead End Clamp for ADSS conductor
The tension clamp is designed for service line with 1 conductor.
-Clamp body is made of high mechanical strength and weather
resistant insulation material.
-Special designed clip is used to prevent the bail slippingfrom the
body.
The ADSS tension clamp body, the main mechanical component is
manufactured in heavy duty weatherproof synthetic material.
The wedge, made from synthetic material exerts necessary mechanical
pressure in retaining the cable in the body of the clamp.
The pull hook is made from anti corrosion rod.
For anchoring isolated coaxial and unipolar cables.
Feature of PA series Anchor clamps
1.Simple and fast installation requiring no tools.
2.Suits to all field configurations.
3.Possible to mount on pole line hardware with open or closed eye.
4.Mechanical traction resistant.
5.Supports industrial duty tension.
6.Corrosion resistant.
7.Weatherproof.
For the correct installing PA25 dead end clamp, the following
steps are recommended:
- Loosen the mooring hook from the anchor clamp.
- Place the hook en the place to be mooring point or support, fixing
it inside the body of the clamp
- Remove the wedge from its base and then place the cable within the
clamp.
- Replace the wedge to its corresponding position and proceed to
tense the cable taut.