Shaanxi Zhongtuo Mine Equipment Co.,Ltd |
Verified Suppliers
|
|
Description of Double Hydraulic Cement Grouting Pump
The hydraulic cement grout machine uses compressed oil or
compressed air as the power source, and the cylinder or the
cylinder and the grouting cylinder have a large ratio of the
working area so that the cylinder can generate a high injection
pressure with small pressure.
The grouting pump is suitable for grouting and water blocking,
filling voids, reinforcing broken rock formations, etc. in mines,
tunnels, water conservancies, subways, buildings, bridges, and
other construction sites.
Technical Parameter of Double Hydraulic Cement Grouting Pump
Model | ZKSY90-125 | ZKSY90-125 | ZKSY100-150 | ZKSY70-90 | ZKSY90-100 |
Discharge volume | 7m3/h | 7m3/h | 10m3/h | 4m3/h | 5m3/h |
Pressure | 0-16Mpa | 0-16Mpa | 0-16Mpa | 0-8Mpa | 0-12Mpa |
Power | 11kw | 11kw | 15kw | 5.5kw | 7.5kw |
Outlet diameter | 32mm | 32mm | 32mm | 32mm | 32mm |
Suction port diameter | 38mm | 38mm | 38mm | 38mm | 38mm |
Size | 1700*700*960mm | 1600*900*1000mm | 1700*700*960mm | 1450*760*800mm | 1600*600*950mm |
Weight | 500kg | 600kg | 550kg | 300kg | 380kg |
Precautions of Double Hydraulic Cement Grouting Pump
(1) Always pay attention to the indication of the pressure gauge.
For example, if the indication of the pressure gauge or the safety
device does not work after the pressure is exceeded, the cause
should be found, and the fault should be cleared before starting.
(2) Pay attention to whether the structure of the grouting pump and
motor is normal. When any fault is found, stop the machine
immediately, open the slush valve to reduce the pressure, and
eliminate the fault.
(3) Always pay attention to making Gland compact the packing so
that there is no leakage. If there is still leakage after pressing,
the packing or piston should be replaced according to the specific
situation.
(4) The consistency of the stirred mortar should be measured before
entering the pump. During the test, the consistency meter should be
perpendicular to the surface of the slurry, put down easily, and
sink by its own weight.
(5) After the shutdown of each shift, clean water must be pumped
immediately, and the pipeline and the inside of the pump must be
cleaned until they are cleaned to ensure that the ball valve, the
slurry outlet, the suction outlet, and the slurry valve are clean
and unobstructed.
(6) The upper oil chamber should be filled with oil.