Fully Automatic Floor Grinder Machine Flexible Ride On Trowel Machine

The Working Principle of Concrete Trowel Seat-Driven Machine​

Ride-on double disc gasoline trowel, this ride-on trowel is easy to operate, and the efficiency can reach 400-500m² in one hour. The grinding disc is used for rough grinding on the ground, and the sharpening knife is used for fine grinding on the ground. The working width is 2 meters. It is simple and easy to operate. One car trowel can reach ten hand-held trowels. There is no problem with working efficiency. , This double-disc ride-on trowel is mainly used for slurrying, compacting, smoothing, and polishing concrete floors.
The first is to confirm that the main gate switch is closed. When the ride-on trowel starts, do not step on the accelerator. You can start by pulling the damper. After the ride-on trowel starts, return the damper to its original position. The left foot cannot step on the flameout switch. Generally, it is stepped on during an emergency stop, pay attention to the first ignition, and the time for the oil pump to pump oil is about 10 seconds.
The gear must be changed when the machine is off. If the gear cannot be engaged, turn the clutch wheel by hand, and then try again. When the machine is running, the accelerator must be completely released. If the gear cannot be engaged, step on the accelerator and then Release it, wait for the idle speed to return to the original position, and try again.
Special attention needs to be paid to turning on the ride-on trowel, and you need to hold the joystick tightly to keep the fuselage balanced. When the ride-on trowel is working, you must hold the ride-on trowel firmly, and it should be done at a time when working on the floor. Adjust the direction to prevent the machine from losing control, and grind first, then finely.

Advantages of Concrete Trowel Seat-Driven Machine​

1. Start with the engine of the ride-on trowel, and assemble various types of high-horsepower engines such as Honda, Lifan, or customized diesel engines for you to choose from to meet the construction needs of different customers and make the construction process. Ensure that the power is full, and the optimized engine design can ensure sufficient fuel, saving daily refueling costs. 2. In the past, the walk-behind trowel only had one grinding disc, and the working area was small, so the construction efficiency could not be improved. However, the ride-on trowel can install two grinding discs at the same time, with a large working area of two meters, and the construction efficiency is improved. more than ten times.
2. Its own weight is more than 300 kilograms. It can also have a good compaction effect on the concrete pavement during construction, and the quality of finishing and polishing can also better meet the requirements of the project.
3. In addition, the handling of details of the ride-on trowel is also very user-friendly, such as walking wheels for convenient transitions, LED lights in the front, two in the rear, oversized water tanks, and independent sprinkler systems, etc., all make the operation and performance of the ride-on trowel more excellent.