Shaanxi Zhongtuo Mine Equipment Co.,Ltd |
Verified Suppliers
|
|
Model specifications | Nominal tensile force (KN) | Nominal oil pressure (Mpa) | Through-hole diameter (mm) | Install limit plate aperture (mm) | Mounting tool (mm) | Outside diameter size (mm) Diameter * Height |
YDC650 | 650 | 48 | 72 | 99 | 95 | 200*385 |
YDC1000 | 1000 | 50 | 78 | 111 | 111 | 230*385 |
YDC1500 | 1500 | 52 | 94 | 150 | 150 | 270*390 |
YDC2000 | 2000 | 53 | 118 | 177 | 177 | 320*400 |
YDC2500 | 2500 | 52 | 128 | 210 | 185 | 345*400 |
YDC3000 | 3000 | 52 | 135 | 190 | 185 | 370*400 |
YDC3500 | 3500 | 51 | 160 | 232 | 232 | 420*400 |
YDC4000 | 4000 | 52 | 165 | 252 | 252 | 450*410 |
YDC5000 | 5000 | 52 | 196 | 260 | 265 | 500*410 |
YDC6500 | 6500 | 53 | 220 | 295 | 235 | 580*420 |
YDC10000 | 10000 | 50 | 270 | 440 | 415 | 740*570 |
Features of Muti-Strands Post-Tension Jack
1. The muti-strands post-tension jack is a special tensioning
jack used for tensioning steel strands and other prestressed
tendons. Generally, it needs to be used in conjunction with the
tensioning oil pump. The power for tensioning and returning to the
top is provided by the high-pressure oil of the tensioning oil
pump. According to the different structures, it is divided into
front card tensioning jack and through-center tensioning jack.
2. The tensioning jack has a compact structure, stable operation
during tensioning, high oil pressure, large tensioning force,
large-span structure, long wire bundles, etc. Tension construction
projects such as hydropower dams and high-rise buildings.
Operation Notes of Post Tension Jack
1. If there is a runaway phenomenon during use, you can first
loosen the oil drain screw on the pump body, lift the pump body
upright and head down a few times, and then tighten the oil drain
screw, you can continue to use.
2. When there is a load, do not remove the quick connector to avoid
accidents and damage to the parts.
3. The machine uses oil as the medium, and the maintenance of the
oil and the machine must be done well to avoid blockage or oil
leakage, which will affect the use effect.
4. For a new or long-established hydraulic jack, because there is a
lot of air in the oil cylinder when it starts to use, the piston
rod may have a small sudden jump. The hydraulic jack can be
reciprocated 2-3 times without load to eliminate air in the cavity.
The jack that has been idle for a long time will be hardened due to
the long-term non-working of the seal, which will affect the
service life of the hydraulic jack. Therefore, when the hydraulic
jack is not in use, the hydraulic jack should be reciprocated 2-3
times a month with no load.