Automatic PVC Pre Milling Edge Banding Machine Double Glue Pot Edgebander Machine

The main function of the machine is introduced:

♦ Preheating: A function of heating the board before gluing, in order to stick it more firmly with the edge band after gluing.
♦ Pre-milling: To deal with the burr on the end face of the plate, it can avoid some defects caused by the precision sawing process.
♦ Welting: Glue the edging tape to the sheet and press it tightly.
♦ End trimming: Cut off the excess edge banding on the front and back of the plate after welting, so that the edge banding and the end face of the plate are flat.
♦ Trimming: Trimming is a function including rough trimming, fine trimming, profiling trimming, and edge scraping. Smooth and round, so that it achieves a beautifying effect.
♦ Polishing: Use a soft material polishing wheel to throw the working surface into a glossy finish to achieve better results.

PLC intelligent control, independent liquid crystal display can see the running process of the machine more clearly and comprehensively, which is convenient, quick and easy to use, real-time monitoring, real-time adjustment, more accurate, high-efficiency production, and the edge sealing effect is not compromised.

Pre-milling, the first process when the sheet enters the conveyor belt, the diamond double milling cutter is used to trim the edge chipping, corrugation and burr phenomenon of the sheet cover again, so as to achieve better edge sealing effect.

The edge-sealing gluing device heats the sol through the gluing pot, and adopts the spiral structure to deliver the glue. The gluing speed is fast, uniform, and the adhesive force is firm.

The end trimming device, through the structure of automatic mold tracking and high-frequency high-speed motor, ensures that the cut surface is smooth and smooth, and has the protection function of flushing the plate to enhance the stability of the flush.

Rough trimming device, the cutter at the rough trimming part is a flat knife, which is used to trim the excess edge sealing material on the upper and lower parts of the edge banding of the processed sheet.

Finishing device, the finishing knife is R2 inclined knife, which can leave 5-6 wire allowance for the next scraping process. The automatic tracking of the mold and the high-frequency motor are used to achieve fast cutting, and the R2 inclined knife is used to repair the radian.

Scraping device, profile scraping, is used to eliminate the secondary wave marks caused by the cutting process of non-linear motion of trimming, so that the upper and lower parts of the plate are more smooth and tidy. better.

The polishing device cleans the processed plate with a cotton polishing wheel, removes excess glue stains, and makes the edge banding section smoother and tidy through polishing.