2.2 kw 1300mm Width Low Noice Shuttleless Weaving Machine For
40-400 mesh/inch
Summary
The light-duty metal wire net weaving machine is applicable for the
industry of metal wire net weaving, and it can be used to weave
mesh nets, microgroove nets and other nonmetal nets. The products
weaved are widely used in various industries including petroleum,
chemical industry, machinery, and aviation, etc.
Main features
- It is highly adaptive to metal wires.
- It has a large range for adjustment and can weave in various
patterns including plain weave, tilted weave, bead pattern, and
tapered contrast microgroove.
- The weft wire is linearly led in without any shuttle, the warp line
feeding and take-up are carried out mechanically and automatically,
the opening size is small, and the net surface is flat and orderly
without any defects.
- It works automatic stopping and displaying functions at any warp
broken or weft broken.
- The whole machine works stably in a low center of gravity and a low
level of noise.
Main Parameters:
TYPE | ZWJ-1300B | ZWJ-1600B | ZWJ-2100B |
MESH SIZE | 40-400mesh/inch | 40-400mesh/inch | 40-400mesh/inch |
WIRE DIAMETER | 0.025-0.200mm | 0.025-0.200mm | 0.025-0.200mm |
BEATING-UP FREQUENCY | 70 r/min | 70 r/min | 70 r/min |
MESH WIDTH | 1300mm | 1600mm | 2100mm |
MOTOR POWER | 2.2kw | 2.2kw | 2.2kw |
OVERALL SIZE | 2.6m*2.8m*1.4m | 2.6m*3.1m*1.4m | 2.6m*3.6m*1.4m |
Main components and specification
In the direction of the technical flow for weaving, it mainly
consists of: take-up unit, weft beating-up unit, opening unit, and
warp feeding unit, etc.
Operation
- The weaving machine can be operated through press buttons and turn
knobs, shown as Fig. 1.
Forward | Inch | Stop | Reverse | Manual | Automatic |
О | О | О | О | О |
- The weaving machine can be started up and stopped at any running
position.
-
- It has the function of automatic stop and red/green light
indication at weft or warp broken.
-
- Turn the knob to the MANUAL stage to release the motor brake for
manual trial running and adjusting.
-
- Turn the knob to the AUTOMATIC stage and then press the FORWARD
button to bring the weaving machine into normal operation.
- At a fault of weft broken or warp broken, the weaving machine will
be automatically stopped and the red/green light will give an
indication. The weaving machine can be brought back into normal
operation after the fault is removed, the STOP button is pressed
down, and the indicator is turned off. If the indicator does not
turn off when the STOP button is pressed down, and the weaving
machine can not be brought back into normal operation even by
pressing down the FORWARD button, it means the fault hasn't been
removed yet.
- When necessary, the weaving machine can be stopped at any running
position by pressing down the STOP button.
-
- The weaving machine will be brought into reverse running by
pressing down the REVERSE button. Usually reverse running is
required at any weft broken, but it is recommended not using this
function frequently otherwise the rapier will break off the warp
line or the motor will be damaged because of overheat.
-
- The weaving machine will be inching by pressing down the INCH
button, but it is recommended not using this function otherwise the
motor will be damaged.
-
- Installation and Tiral Operation