|
[China]
Trade Verify
Address: B5 Chao Yang Factory, Caohu Industrial Park, Xiangcheng Economic Development Zone, Suzhou, Jiangsu Province P.R.C
Contact name:Matt Liang
Suzhou Alpine Flow Control Co., Ltd |
|
Verified Suppliers
|
|
|
Electrical Type Pump Control Valve Ductile Iron Body Epoxy Coated
Description:
A76D is an electrical type pump control valve.
When pump opens, PLC controller will transmit signal
then open the solenoid valve which can help the valve fully
open and minimize the headloss,and the needle valves can be
adjusted by controlling the opening and closing speed.
When the pump stops, PLC will transmit signal and open the
solenoid valve and close the A76D slowly. After the valve close,
the limit switch on the valve will send signal to PLC to shut down
the pump. This active protection will prevent water hammer when
pump stops.
. When power failure, A76D will act like a non-slam check valve. It
will close quickly. This will minumize water hammer and water
slamming
Technical Data:
| Size range | DN 50-800MM |
| Pressure ratings | 1.0Mpa, 1.6Mpa,2.5Mpa |
| Flange | 1.0Mpa,1.6Mp,2.5 Mpa |
| Working temperature | -10°~80°C. |
| Flow media | clean water |
DN50-DN350
Parts list :
| No. | Description | Material | Standard |
| 1 | Body | Ductile Iron | GJS500-7 |
| 2 | Seat | Stainless Steel | AISI304 |
| 3 | O-ring | Rubber | NBR |
| 4 | Seat Retainer | Stainless Steel | AISI304 |
| 5 | Seal | Rubber | EPDM |
| 6 | Dics Holder | Carbon Steel | CS/1045 |
| 7 | Stem | Stainless Steel | AISI304 |
| 8 | O-ring | Rubber | NBR |
| 9 | Internal Body | Ductile Iron | GJS500-7 |
| 10 | Bush | Bronze | C61900 |
| 11 | Diaphragm | Nylon Reinforced Rubber | EPDM+Nylon Fabric |
| 12 | Fixing holder | Ductile Iron | GJS500-7 |
| 13 | Bonnet | Ductile Iron | GJS500-7 |
| 14 | Nut | Stainless Steel | AISI304 |
| 15 | Screw | Stainless Steel | AISI304 |
| 16 | O-ring | Rubber | NBR |
| 17 | O-ring | Rubber | NBR |
| 18 | O-ring | Rubber | NBR |
| 19 | Spring | Stainless Steel | AISI304 |
| 20 | O-ring | Rubber | NBR |
| 21 | Nut | Stainless Steel | AISI304 |
| 22 | Plug | Stainless Steel | AISI304 |
| 23 | Screw | Stainless Steel | AISI304 |
| 24 | Nut | Stainless Steel | AISI304 |
DN400-DN800
Parts list :
| No. | Description | Material | Standard |
| 1 | Body | Ductile Iron | GJS500-7 |
| 2 | Seat | Stainless Steel | AISI304 |
| 3 | Screw | Stainless Steel | A2 |
| 4 | Washer | Stainless Steel | A2 |
| 5 | Bolt | Stainless Steel | A2 |
| 6 | Bonnet | Ductile Iron | GJS500-7 |
| 7 | Stem nut | Bronze | C61900 |
| 8 | Fix Washer | Stainless Steel | AISI304 |
| 9 | Fix Holder1 | Ductile Iron | GJS500-7 |
| 10 | Eye Bolt | Carbon Steel | CS/1040 |
| 11 | Diaphragm | Nylon Reinforced Rubber | EPDM+Nylon Fabric |
| 12 | Fix Holder2 | Ductile Iron | GJS500-7 |
| 13 | Internal Body | Ductile Iron | GJS500-7 |
| 14 | O-ring | Rubber | NBR |
| 15 | O-ring | Rubber | NBR |
| 16 | Bush | Bronze | C61900 |
| 17 | Spring | Stainless Steel | AISI304 |
| 18 | Dics Holder | Ductile Iron | GJS500-7 |
| 19 | Seal | Rubber | NBR |
| 20 | Seal Retainer | Ductile Iron | GJS500-7 |
| 21 | Stem | Stainless Steel | AISI304 |
| 22 | Bush | Bronze | C61900 |
| 23 | O-ring | Rubber | NBR |
| 24 | Cap | Stainless Steel | AISI304 |
| 25 | Plug | Stainless Steel | AISI304 |
| 26 | Screw | Stainless Steel | A2 |
| 27 | O-ring | Rubber | NBR |
| 28 | Screw | Stainless Steel | A2 |
| 29 | Nut | Stainless Steel | A2 |
Outside piping diagram:
