Stable Performance Magnetic Particle Flaw Detector AC220V Power Input CDX-Ⅲ

Mitech Magnetic Particle Flaw Detector CDX-Ⅲ with high pricision and stable performance

Technical Parameters

Power input: AC220V, ±10%, 50HZ,5A

Power output: AC36V*2, 15A, can equip A, D, E, O four probes

Flaw detection speed: ≥6m/min

Probe temperature-rise: ≤60℃

Working conditions: when continuous working, magnetizing time≤3s, clearance time≥5s

Weight: about 7.0KG

Lifting: ≥45N(no less than 5kg)

Complex sensitivity: clearly show the artificial notch of type A 30/100 standard specimen

Standard Configuration

Maintenance

Mitech multifunctional magnetic powder flaw detector is precision detector, please pay attention to the following items:

Avoid Plugging and pulling the wire while the instrument is on.

After use, wipe out the oil on the surface to avoid rain, oil or other liquid into the machine.

Strong vibration should be avoided when moving the machine, it is usually kept in dry and ventilated place.

Regular charge is needed if not used for long, in case of damages caused by damp.

Wait for more than 5 seconds before reboot, or it may lead to error .

Make sure the contact is well before you press the probe button and release the button before finishing.Active joints should be regularly lubricated.

If the power light fails, it is mainly because the fuse damage or light problem.

If the magnetizing light fails, it is likely that the light bulb damage or relay fault. Thyristor damage is also possible.

Types of probes