Active Member
|
[China]
Address: Virock Road 8, Wangcheng economy & technology development zone, Changsha, Hunan, China
Contact name:SHIRLEY WU
VIROCK TEXTILE PRINTING&DYEING MACHINERY CO.,LTD |
|
|
Simple operation heat setting stenter , pin clip combined , PLC inverter cntrolled
1. Technical data:
| Machine hand | Left or right hand |
| Nominal width | 1400--3800mm |
| Effective width | 650--(w-200)mm |
| Design speed | Max.150m/min |
| Transmission mode | Multi unit synchronous AC motor frequency converter speed drive, a cloth area TV monitor, touch screen computer control of process parameters. |
| Overfeed | A cloth feeding range -10%-+30% |
| The cloth feeding range -10%-+10% | |
| The needle brush over feed range -10%-+30% | |
| A cloth feeding range -10%-+30% | |
| A method of cloth | Pin / clip / combined |
| Drying room temperature | 230C(max) |
| The pressure of compressed air | 0.4-0.5MPa |
| Size and shape | Long (17606+N*3000) mm/ (+2200) mm/ high 4000mm wide |
| Installed capacity | App. 150 KW |
| The heat source | Thermal oil / gas / electric / steam |
2. Machine character:
1) Machine equip infra-red centering controller in infeeding side, auto centering
executor is in slide mode, action is stable, response is very smart, very suitable for correcting the high speed movement fabrics; The centering roller surface is with little friction and little tension.
2) Equip padder(optional) after the infra-red center device, the squeezing roller is horizontal structure, pneumatic discharge waste liquid. All the turning shafts inside the liquid trough are made of stainless steel;mixed the paste inside the liquid trough, through the high pressure rubber roller, the paste is pressed into the fiber, which made the fabrics uniform inside and outside, though adjusting the cylinder pressure, the pressure on the squeezing roller will be adjusted, squeezing out the extra liquid from the fabrics. Then core of the squeezing roller is made of steel, covered by special glue from America, the squeezing ratio is uniform, there is a stainless steel spreading shafe in the infeed part, driven by motor separately.
3) Width adjusting:
The chambers equipped with individual motors and controllers for the individual screws which are controlled from the control box either individually or all at a time. A suitable indicating arrangement is provided on the Operating bridge or box.
4) Air circulation system:
The machine chamber is some simple and efficient dryer which equipped with closed circuit air circulation system, using Radial Blowers directly coupled with AC motors which can be controlled by Invertors. The machine equipped with good insulation seals and has lower energy consumption.
