|
[China]
Trade Verify
Address: No.4 Building , No.388, Kongjiang Road,Yangpu District,200093,Shanghai,China
Contact name:Emily
Shanghai Wind Automation Equipment Co.,Ltd |
|
Verified Suppliers
|
|
|
No Hook Commutator Armature Dual Flyer Winding Winder
For Vacuum Cleaners Hammers Power Tool Motor WIND-ST-TD2B
Winder Main Data and Application :
Armature winder for slotted type commutator armature,Vacuum cleaners hammers power tool
in which the commutator is without hook tang and have a special way for pressing and hooking
the copper wire to commutator wire slot area
| Armature Informaiton | Size | Remark |
| Copper Wire Diameter | 0.20~1.2mm | AWG17 ~ AWG32 |
| Armature Diameter Range | 20~90mm | 0.787'' ~ 3.543'' |
| Armature Stack Length | 10~130mm | 0.394'' ~ 5.118'' |
| Commutator Diameter | 8~60mm | 0.315''~2.362'' |
| Armature Slot Number | Odd, Even Slots | |
| Turns No. | 0~99999 | |
| Flier Fork Speed | 0~2000RPM | |
| Indexing Speed | 0~2500RPM | |
| Total Power | 3.5KW | |
| Operation Method | Step, Auto, JOG | |
| Power Source | AC380V 50/60Hz | 3Phase |
| Air Source | 5~7KG/cm2 | 0.5~0.7MPa |
| Gross Weight | about 1000KGS | |
| Dimension | 1530mm x 1280 mm x 1650mm |
Armature Winder Main configuration:
PLC: MITSUBISHI
Servo control system: DELTA
Touch screen: MCGS7062KS
Pneumatic system: AIRTAC
Tension :Hysteresis tension
Linear guide way: HIWIN
Main electrical components:Korea and Japan
Armature/Rotor Winder Advantages:
1. Armature winder WIND-ST-TD2B is dedicated machine for winding slotted type
no hook commutator armature,obtain good adaption for slot type commutator with groove
2. No need to work with special designated slotting undercutting machine
3. Comparing to hook type armature, slotted type armature save copper wire and reduce cost,
but winding slotted type armature can be a challenge
because slotted type commutator armature winder is different from hook type armature winder
WIND-ST-TD2B is the best winder for slotted type commutator in China during machine manufacturers
4. 98% yield rate above assured when the slot commutator quality is good
Armature Winding Machine Operation process:
Operator only need to load and unload armature,
other actions such as hooking, winding, indexing and cutting are automatcial process
Winding and welding are the two most improtant process in building motors, WIND-ST-TD2B winding
machine is mainly for automatical lap winding a slotted type commutator armature as below:
1. Straight stack armature and
2. Skew lamiantion rotor
The purpose of these armature winder is to create a magnetic field lap winding coil
when a current is run through them,
