50MT Straight Drive Armature Winding Machine / Flat Wire Stamping Punch Forming Machine

50MT Straight Drive Starter Armature Flat Wire Stamping Punch Forming Machine WIND-AWF-F

(1) Application

Flat wire forming machine produce conductor for starter armature bare wire without enamel.

(2) Advantages

1. High efficiency, Cycle time Around 25pcs/ minutes

2. Four cutter cut the flat wire

3. Mitsubishi PLC, Weinview touch screen,Airtac cylinder and valve,Schneider Electrical components

4. Flat wire forming machine WIND-AWF-F is comprised of  three major parts,

    wire feeder,straightening machine and feed forming

5. The feeding length can be setted on screen, mechanical linkage automatical punch forming

6. Fomring angle is adjustable  lainkag

(3) Parameter

Power Supply Voltage: AC220V±10% 50Hz

Air source Pressure: 0.5~0.7Mpa

Varnish Removing Length: 0~50mm

Wire Feeding Length: 150~400mm

Rated Capacity: 2KW

(4) Configuration

Product related:

The 50MT is a straight drive starter for heavy duty and industrial applications.

The 50MT is available in 12, 24, 32, and 64 volt models and can start engines.

with displacement up to 29.5 liters.

Please click below picture to view video

In theory, forming round coil and flat coil are similar, but in reality, the flat wire forming is complicated than

round wire forming. At the flat wire R angle, the enamel could not be removed easily and fully, and our

machine overcome the problem. Most of the domestic starter armature manufacturers mainly use paint

chemical methods (paint remover) to remove enamel,the disadvantage is the length can not be controlled,

low efficiency, also have some damage to the human body. Our equipment Flat wire winding machine for

producing starter coil had solved this problem in the year 2014 and customers from aerospace filed had

purchased this machine and gave good feedback.