|
[China]
Trade Verify
Address: No.4 Building , No.388, Kongjiang Road,Yangpu District,200093,Shanghai,China
Contact name:Emily
Shanghai Wind Automation Equipment Co.,Ltd |
|
Verified Suppliers
|
|
|
No Hook Commutator Armature Winder For Vacuum Cleaners Hammers Power Tool Motor WIND-ST-TD2B
Application:
Armature winder for slotted type commutator armature,Vacuum cleaners hammers power tool
Advantages:
1. Armature winder WIND-ST-TD2B is dedicated machine for winding slotted type
no hook commutator armature,obtain good adaption for slot type commutator with groove
2. No need to work with special designated slotting undercutting machine
3. Comparing to hook type armature, slotted type armature save copper wire and reduce cost,
but winding slotted type armature can be a challenge
because slotted type commutator armature winder is different from hook type armature winder
WIND-ST-TD2B is the best winder for slotted type commutator in China during machine manufacturers
4. 98% yield rate above assured when the slot commutator quality is good
Winding Machine Operation process:
Operator only need to load and unload armature, other actions such as hooking, winding, indexing and
cutting are automatcial process
Winding and welding are the two most improtant process in building motors, WIND-ST-TD2B winding
machine is mainly for automatical lap winding a slotted type commutator armature as below:
1. Straight stack armature and
2. Skew lamiantion rotor
Lap winding with
double flyer wire
gauge range
|
Usually 0.20~1.2mm, Max machine handled 1.35mm (about AWG16)
|
Armature
commutator type
|
Slotted type riser type not hook type
|
Automatic or
semi automatic |
You only need to load and unload armature, other actions such as hooking,
winding, indexing and cutting are wound by machine automatcially
Wire size and Wire slot size(Length,width and depth), the wire slot should have
enough space for the wire to stay inside Wire size 17AWG (1.15 mm), Slot: blade
width 1.143, length=7.14 mm, depth= 5.95 mm
and we think if the depth is bigger, the wire can acquire more space to stay inside
slot, while depth is more, length is more too,
4.2 Could you please check if the commutator was pressed consistanctly each time
at same location according armature stack? The push pin witness marks on the
commutator are consistent.
Because armature commutator and stack position is very important for indexing
consistantly Fully automatic winding machine with Japan as the pioneer, the rising
demand for high quality products and low labor cost, operator only need to ensure
enough raw materials, and replace them in time without workpiece or copper wire,
so that continuous production can be ensured. The number of shaft is usually high,
so as to achieve high efficiency production. A machine with enough automation can
meet the requirements of an employee handle two or three winding machines at the
same time.
|
Please click below picture to view video
