|
[China]
Trade Verify
Address: No 12, Zhongjiang Village, Sanhekou Development Zone, Zhenglu Town, Tianning District, Changzhou City, Jiangsu Province, China
Contact name:Vicky
JIANGSU GUOJIN DRYING TECHNOLOGY CO., LTD |
|
Verified Suppliers
|
|
|
Bulk Material Dense-Phase Pneumatic Conveying Machinery Transfer System
Dense-phase pneumatic conveying system is specially applied to a variety of dust long-distance sealed transport; the adaptive conveying distance equivalent is 50-500 meters, transport materials: fly ash, lime powder, cement, aluminum powder, mineral powder, saw dust, straw and so on. The equipment is simple, with small occupation area, it can make full use of space, and pipelines can be flexible layout, so that the configuration of the plant equipment will be more rational. System configuration is complete, PLC set control the entire system, fully automated operation, easy maintenance.
Working Principle
In the feeding process, the material is fed into the sending tank through the double butterfly valve or expansion butterfly valve, and the replaced air is released through the exhaust valve, which makes feeding easier and eliminates the reverse pressure that hinders the flow of materials. When the sending tank is full (up to 90% of the tank volume indicated by the level meter), the feed valve and exhaust valve are closed and sealed at the same time. Then, compressed air is added to the top of the sending tank through the inlet valve, and the added compressed air is mixed with the materials. When the pressure in the tank reaches the set value, the bottom discharge valve will be opened automatically, and then the whole conveying pipeline will be pressurized The material is transported in the form of plunger until the material is emptied. When the pressure in the sending tank drops to zero, the pneumatic supply is closed, and a small amount of residual gas is discharged from the sending tank and the transmission pipeline.
Product Features
1) It is suitable for scattered transportation from one place to several places. That is, the feed point is one, and the discharge point can be one or more.
2) Compared with the suction type, the concentration and transport distance can be greatly increased.
3) Under the condition of positive pressure, the material is easily removed from the discharge port, so the structure of separator and precipitator is simple, and generally there is no need to lock the air.
4) Blower or air compressor at the first end of the system, requiring low level of air purification.
5) Under the positive pressure, the material is not easy to enter the conveying pipe, so the structure of the feeding device is more complicated.
6) The material runs in the closed tube, does not raise dust, and the environment is clean and tidy.
7) Low energy consumption and low noise.
8) The pipeline layout is flexible and covers a small area.
9) Can be long-distance transmission, up to more than 500 meters.
Product Paremeter
| Model | DPCS-1.5 |
| Body Inner diameter(mm) | 1200 |
| Total volume(M3) | 1.5 |
| Body material | Q235-B |
| Operation Temperature(oC) | <120 |
| Max. design pressure(Mpa) | 0.78 |
| Operation pressure(Mpa) | 0.2-0.5(Basis on the conveying distance) |
| Max. conveying distance(m) | <1000 |
| Outlet conveying diameter | DN100 |
| Air consumption(m3/min) | 5-10 |
Structure composition
Product Picture
Contact me
