Tri - Proof Fixtures Microwave Movement Sensor Remote Controllable

Specially For Tri - Proof Fixtures , Microwave Motion Sensor Switch , 1 ~ 10V dimming , Remote Controllable
 
12V DC input motion sensor with 1~10v dimming output, special housing designed for Tri-proof fixture application. Infrared remote for end-user to change all the settings. Dual-processor technology to differentiate the natural light and lamp light, daylight monitoring function available.
 
 
Features--
 

5.8GHz C-band microwave, tri-level dimming control.

Input voltage 12V DC (5V & 24V DC version available on request).

Input current:≥25mA.

1~10V dimming output signal.

Dual-processor technology, real Daylight monitoring function for built-in application.

IR remote commissioning, easy setting and user friendly.

Detection range up to 12m in diameter.

Mounting height: 3~6m.

Operation temperature: -20°C~ +70°C.

 
Settings(by remote control IR12)--

Permanent ON/OFF function

Press ^“ON/OFF^” button, fixture goes to permanent on or permanent off mode, sensor is disabled.

*press "Auto” ,”Reset" or “Ambient learn” to quit this mode.

Dim +/-

Press "Dim" button to automatically dim up or down the light brightness during hold-time from 10% to 100%. Another press to lock it down when desired brightness is achieved.

*after desired brightness is locked down, if user wants to dim again reversely, just press the ^“Dim^” button again and then lock down the new brightness again.

Sensor mode

Press ^“Auto^” button, the sensor starts to work and all settings remain the same as the latest status before the light was switched on/off.

Reset function

Press^”Reset^” button, all settings go back to factory default settings.

*Factory default settings--

Sensitivity=100%

Daylight sensor=disable

Hold time=90s

Twilight time=5min

Twilight level=10%

Ambient learn

Press "Ambient learn" button, the latest surrounding lux value overwrites previous lux value learned, and set as the daylight threshold. This feature enables the fixture to function well in any real application circumstance.

Test mode

"Test mode"is for testing purpose only, for users to check the functionality and choose the desired detection range. The sensor goes to test mode automatically after pressing this button.

Users can quit this mode by pressing "ON/OFF", "Reset' or any button of "Hold time". The sensor settings are changed accordingly.

*Test mode defaulted settings—

Daylight sensor=disable

Hold time=3s

Twilight time=N/A

Twilight level=N/A

 
Detection pattern--
 

 
Daylight monitoring function--
 

Utilizing the Dual-processor technology, this sensor can tell the difference of natural light and artificial light(lamp) from behind the diffuser, switch on automatically(even without movements) when the ambient light is below target value, and then switch off automatically whenever the artificial light is not required (ambient light is bright enough).

Note:  Lux-Off sampling time—30s; Lux-On sampling time—10s.

   Lux-On function takes effect only when standby dimming period set at +∞.