Active Member
|
[China]
Address: Unit E, NO.11 XiYuan Eight Road, XiHu District, HangZhou City, Zhejiang Province, China.
Contact name:Monica Yu
POWERFLOW CONTROL CO,. LTD. |
|
|
1. Dimension
2. Connection type
3. Installation
 | Loosen the screw F with a hexagonal wrench and remove the drive rod D |
 | Check that the seal on the transmission rod is installed and in good condition and replace if necessary |
 | Unscrew the clear cap B on the drive and indicate the C on the drive lever |
 | Place drive bar D into the drive and screw threaded lock A onto drive lever E |
 | Use a wrench to tighten the drive rod to the top of the drive |
 | Tighten the drive rod and driver rod with a driver |
 | Install the return sensor housing to the drive rod D, rotate the sensor housing, set the direction of the cable glands, and ensure that the electric shock signal is normal. Use the Allen wrench to tighten the fixing screw F |
4. 1/4, M16*1.5 conversion sleeve installation
