|
[China]
Trade Verify
Address: Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China
Contact name:Zoe Zou
Sinuo Testing Equipment Co. , Limited |
|
Verified Suppliers
|
|
|
EN 60745 Two Stations Circular Saw Switch And Lower Guard Endurance Test Equipment
Product Information:
This test device for circular saw switch and lower guard conforms to EN 60745-2-5: 2010 Annex M21.18, Annex M21.18.301, Annex M21.203, Annex M21.301, figure M.301, IEC60745-2-5:2003 Annex BB.20.102, EN 60745-2-5:2010 clause 17.101 and clause 19.102.3.
It is used to test the circular saw switch performance and circular saw lower guard’s durability and recovery time.
Technical Parameters:
| No.: | Serial No.: | Parameter | Remark |
| 1 | Input Power | 220V/50Hz | |
| 2 | Control System | PLC, 7-inch touch screen | |
| 3 | Station | One (model: SN2802) or two (model: SN2803) optional | |
| 4 | Built-in Load | 0~250V/5KW voltage regulator, equipped with B socket | |
| 5 | Test Cycles | 0-999999, can be preset | |
| 6 | Test Speed | ≥10 freq/min | |
| 7 | Guard Recovery Detection Time | 0.01-9.99s, can be displayed | Recovery time |
| 8 | Circular Saw Switch Locking Device | Lock or release the switch by motor driving | |
| 9 | Operation Buttons | Stop and Start buttons on the panel for operator easily cut off or turn on the power |
This equipment is composed of two parts, the mechanical system and electrical control system.
Mechanical system is the table for circular saw. There are a switch and sample socket on the table, operator can push the switch to turn on or off the load power supply to the test sample; different sizes of circular saws can be placed and fixed on the table; on the table, device for locking the switch of the hand-held circular saw in the “on” position; the blade can extend to the bottom of the table through the middle groove; on the table where under the blade, there are a the lower guard putter and two position sensors , which can be drive the lower guard of the circular saw to be opened or closed.
The electrical control system consists of the load power supply, PLC, 7 Inch Touch screen and etc. Can achieve manual operation and automatic operation.
