|
[China]
Trade Verify
Address: Room 101, 1st Floor, No. 6, Third Street, Pingshan Industrial Zone 511495, Shibi Street, Panyu District, Guangzhou, China
Contact name:Zoe Zou
Sinuo Testing Equipment Co. , Limited |
|
Verified Suppliers
|
|
|
IEC 60884-1:2022 Label Marking Abrasion Test Apparatus For VDE Type Plug Socket
Product Information For Label Marking Abrasion Test Apparatus:
This label marking abrasion test apparatus conforms to IEC 60884-1: 2022 Clause 8.8 figure 5, IEC 60669-1: 2017 Clause 8.9, etc.
Technical parameters For Label Marking Abrasion Test Apparatus:
|
Troubleshooting For Label Marking Abrasion Test Apparatus:
1 If the POWER is turned on, the instrument is not powered on or the power indicator is not light: if the power indicator is damaged, replace the indicator; if there is no power output at the power output terminal, please check the power cord or power socket-outlet.
2 If the power is turned on, the power indicator lights, but the machine does not work when operator presses the SWITCH button. Please check whether there is a disconnection. If there is a disconnection, please connect it in time. If there is no disconnection of the relay, indicating that the counter is damaged, the counter should be replaced in time.
3 When the number of times set on the counter is finished, but the motor does not stop working, indicating that the counter is damaged.
4 If the power indicator light is on but the counter has no display, it means that the counter is damaged and the counter needs to be replaced.
Maintenance Notes For Label Marking Abrasion Test Apparatus:
1 The instrument must be placed on a stable surface before use.
2 It is not allowed to move the machine during use.
3 Select the appropriate power supply voltage, should not be too high, to avoid burning the instrument.
4 If the instrument works abnormal, please contact with us for timely processing.
5 The instrument must be used in a good ventilation environment.
6 Please add lubricating oil to the mechanical transmission part in time due to the large operating load of each component of the button mechanism.
7 After each test is completed, operator should clean the machine.
8 The control box part must be wiped with a dry cloth.
