Dongguan Landtool New Materials Co., Ltd |
Verified Suppliers
|
|
BLUESTAR EMUL E8455 Silicone Softener For Fabrics And Wool
EMUL E8455 is a high viscosity hydroxyl-terminated polymethicone non-ionic water emulsion with slightly anionic properties. With chemical activity, and outstanding stability, lubricity, is a general-purpose product
Natural leather brightener;
Smoothing agents for fabrics and wool;
Release agents for industrial rubber, tires, plastics and foundry
materials;
Additives for maintenance products: polishes for floors and
furniture, leather maintenance products, etc.
EMUL E8455 Emulsion provides the following properties when dried to
film:
Excellent stability;
Chemical reactivity;
Waterproof;
Good release properties;
Incompatible with many organic substances.
EMUL E8455 emulsion has low viscosity and is easily soluble in
water. When diluting, it is recommended to add water to the
emulsion, the reverse order of addition (adding the emulsion to the
water) is not recommended.
Hard water is not recommended and the CaCO3 content in the water
must be below 250ppm.
EMUL E8455 Emulsion is used in:
Leather Brightener: Treat leather with a spray gun or roller and
dry under normal conditions. EMUL E8455 Emulsion improves product
gloss and smooth hand. For leather treatment, EMUL E8455 is
recommended to be diluted. Typical applications are 1-2 parts of
EMUL E8455 emulsion diluted with 8-9 parts of water. EMUL E8455 can
also be used in combination with other leather treatment
auxiliaries to treat leather products such as genuine leather or
artificial leather by spraying or dipping.
——Spraying process:
Dosage: It is recommended to add 10% of the total formula to the
slurry sprayed on the top layer;
Drying temperature: drying at about 100℃;
Placement: Test the hand feeling after placing it at room
temperature for 24 hours to absorb moisture;
The following are the recommended formulations for synthetic and
artificial leather:
EMUL E8455………………………………………… 10%~20%
Deionized water…………………………………………90%~80%
Using spraying process, 100 ℃ drying.
Rubber and plastics industry: For the exact concentration required
for each specific case, the recommended emulsion concentration for
the first experiment is 20 parts water (hardness <250ppm as
CaCO3) to one part EMUL E8455. When preparing, directly add the
required amount of water under stirring conditions.
If the release effect of the demolded article or the surface finish
of the molded article is unsatisfactory at this concentration, the
concentration of EMUL E8455 should be gradually increased, stirring
after each addition, until satisfactory results are obtained.
If a concentration of 1:20 gives satisfactory results, add water
gradually, stirring after each addition, until you find the lowest
concentration for good mold release.
The application process usually uses a spray gun, which gives a
very fine spray that will produce a thin, uniform film.
Precautions:
This lotion should be used in:
- completely clean, grease-free moulds,
-Hot molds (110 - 120°C) to ensure instant evaporation of water,
beading must be thoroughly removed before molds are filled and
closed.
The amount of EMULE 8455 emulsion to be used depends on the nature
of the different substrates to be treated and the desired effect.
Storage & Packing:
Stored in the original airtight container at 5°C~30°C, the standard
shelf life of EMUL E8455 Emulsion is 6 months from the date of
manufacture. Please refer to the storage advice and expiration date
on the packaging.
After this date, Bluestar Silicones will no longer guarantee that
the product meets the sales target.
packaged in 200kg drum, or 1000kg box