Portable 200W Jewelry Laser Soldering Machine For Jewelry Production

Portable 200W jewelry laser soldering machine for Jewelry production
 

Product Description

Laser spot welders deliver exceptional laser welded joint quality in a fast and easy-to-use machine. Within minutes, spot and seam welding with micron precision is possible, even in complex areas.

The rule of thumb is:
If you can see the joint, you can laser weld it. Using a laser, experienced users can join filigree workpieces with a finesse and precision that cannot be achieved with other methods.

Jewelry laser welding machine for ring bangle bracelet platinum soldering Details

 
 
Specification of jewelry laser soldering machine

 
 

Machine video

 
Samples

 
Advantage
Laser-welded joints are strong and can withstand high mechanical strains without any wear. In addition to an adhesive seal, they feature temperature resistance and a non-porous surface. Compared to other joining technologies, the post-processing of laser welding is reduced to a few simple steps or can be completely ignored.
 
 
How to operate the jewelry laser welding machine for ring bangle bracelet platinum
Operating system support languages: Chinese, Turkish, Arabic, English, Korean
 
1. Observation system: The observation system of this jewelry spot welding machine consists of a microscope and a built-in high-definition CCD camera. Users can choose one or two of them as the observation method according to their needs. Both can clearly observe the welding position of the workpiece, which is convenient for welding.
 
2. Adjustment of the CCD cross cursor: If the CCD camera system is in a very clear position and the light spot is not in the center of the cross cursor, you can change the position of the cross cursor by clicking the four middle positions.​​​ On both sides of the screen, make the solder joints in the center of the cursor
 
3. For welding operation, first ensure that the machine is turned on normally, put the workpiece into the sight range of the observation system, and then slowly move to the clearest position of the observation system.
Aim the cursor at the desired welding position, gently step on the foot switch, the machine has laser output for welding.
 
4. Parameter adjustment and focus adjustment. After the first welding, the welding effect of the solder joints does not meet the requirements, and the parameters need to be re-adjusted. Adjust the focal length (-3.0-+3.0), so that the welding effect can meet the requirements, and the welding will not be repeated later. Need to be adjusted again.