|
[China]
Trade Verify
Address: No.265 of zhongshan road ,shijiazhuang city ,heibei province ,china 050000
Contact name:zhijing.gao
Huihao Hardware Mesh Product Limited |
|
Verified Suppliers
|
|
|
| Product Name | Copper plated CD weld insulation pins |
| Material | Mld siteel |
| Pin diameter | 10Ga,12Ga,14Ga in common |
| Pin length | 25mm-250mm ,and the length could made according to the customer’s requirement |
| Washer diameter | 30mm or 38mm dome cap washer in common |
| Surface treatment | Copper plated or galvanized plated |
plated mild steel material capacitor discharge (CD) weld pins
The Capacitor Discharge Weld Pins is a Low Carbon Steel, Stainless Steel or Aluminum weld pin that is ideal to apply
with pin welding or stud welding equipment. Manufactured with a standard capacitor discharge weld tip and flange, the
Capacitor Discharge Weld Pins is popularly used as an insulation fastener, in combination with self locking washers
(or “speed clips”) to secure insulating material.
We recommend Capacitor Discharge Pins for welding to clean surfaces. For difficult surfaces the “Power Base” Weld
Pin is designed to weld through paint and rust to eliminate grinding of the base metal. Both are available in various
diameters and lengths.
| WELD NAILS MATERIAL | STANDARD OF MATERIAL |
| Low Carbon Mild Steel 4.8 (weldable) Stainless Steel A2-50 (weldable) Aluminium Alloy AlMg3 Pure Aluminium Lead Free Brass 4.8 (weldable) | EN 20898-1 EN ISO 3506-3 EN 573-3 EN 573-3 ISO 426 –1 / ISO 1638 |
Capacitor Dischage With Zinc Coated
Capacitor Dischage With Copper Plated
Packing for Cacacitor Discharge
Capacitor Discharge Weld Pins1.500pcs per bags, 10 bags per carton. if the length too long,
we will be according your requirements to pack.
| Package of the copper coating weld pins | ||||
| term | length | width | height | loading |
| carton size | 28cm | 20cm | 25cm | 3000pcs |
| pallet | 1120mm | 1000mm | 1100mm | 100 cartons |
| 20ft container | 18 pallets | 40ft container | 36 pallets | |
The standard, portable CD system consists of:
1Gun with Cables is used to command the power unit and deliver weld current, with the Gun also serving as the
Pin h.The Controller [ or Power Unit] which is plugged into the one-hundred-and-ten-volt outlet.
2.The CD older to properly place the pin during welding.
3.Then, on the other side of “the circuit” a ground cable and clamping connection is attached to the work-surface to complete
our Capacitor Discharge connections.
4.And finally, special Accessories are used to hold the Pin in the Gun.
